Calibre UK VANTAGE-HD manual Below details the connections to Vantage-HD

Page 5

IF THE REMOTE CONTROL IS TO BE LEFT UNUSED FOR AN EXTENDED PERIOD OF TIME PLEASE REMOVE THE BATTERIES TO PREVENT POSSIBLE DAMAGE CAUSED BY LEAKING

1.6.Serial Control

Vantage-HD has a serial port which allows for the unit to be controlled via an integrated home control system. The connector on Vantage-HD is a 9 way D-Type (female).

Pin 2 = Tx Pin 3 = Rx Pin 5 = Ground

The type of cable required will depend on your home control system but typically a 9 way Male to 9 way Female connected straight through will allow serial control.

The serial control codes can be downloaded from www.calibreuk.com, please also note that serial control may require the application of a firmware upgrade to your unit via its USB port.

1.7.Infrared Control

The infrared control codes can be downloaded from www.calibreuk.com

1.8.Firmware Updates

Calibre operates a policy of continued product improvement as a result we may periodically issue firmware updates, these are downloaded to the Vantage-HD via the USB port.

Full details of the updates and how to download them are available on our website www.calibreuk.com

1.9.Rear Panel Connections

The following inputs are located on the rear panel of the Vantage-HD

1.Composite video via RCA jack (2x)

2.S-Video via 4 way mini DIN socket (2x)

3.Component video with or without separate sync via 3/4 RCA jack (2 sets)

4.HDMI version 1.1 (2x)

5.Expansion slot for input expander cards - takes HDMI card or HD-SDI card

6.Computer (SVGA) via 15 way HDD

7.Analog audio stereo pairs via RCA jack (4 sets)

8.S/PDIF coaxial audio (2x)

9.S/PDIF optical audio (2x)

10.Power jack

The following outputs are located on the rear panel of Vantage-HD

1.Analog video output via 15 way HDD (1x)

2.HDMI version 1.1 (1x)

3.Analog audio stereo pair via RCA jack (1 set)

4.S/PDIF coaxial audio (1x)

5.S/PDIF optical audio (1x)

Figure 1 below details the connections to Vantage-HD.

Figure 1 Rear Panel Connections

Issue 1.0.2

28 March 2006 © Calibre UK Ltd

Page 2 of 30

Image 5
Contents VANTAGE-HD Welcome to the Vantage-HD Manual Copyright & Limited WarrantyContents Product Description Below details the connections to Vantage-HD Connecting VANTAGE-HD to the Display Device Configure Connect PowerSwitch on Output modeSelect display Device resolution Frame Rate Select OutputImage ProjectionPixel Clock and Phase Adjustments Within the Display Optimize Display Device SetupDelay Mode Setting AudioWarp Correction GammaConnecting VANTAGE-HD Inputs Reset Channel Freeing Input Channels Selecting AN Input Pixel Clock & Phase Adjusting AN InputMpeg Video input signals onlyInput gamma mode Color temperatureBlack Level Input CaptureSelecting the input Picture in PicturePositioning the PIP OSD not visiblePicture In Picture Menu Issue Vantage-HD Information Vantage revision Information MenuInput Source Input FormatConfiguration Menu Factory Reset 0SD TimeoutInfoscreen Timeout VBP Output Mode DetailsPage NTSC, PAL, Secam Input Signal DetailsPage Power Supply Specification Regulatory Approvals Safety Warning Environmental and SafetyHdmi Connection Advice Issue Warranty & Service Advice