Calibre UK VANTAGE-HD Picture in Picture, Selecting the input, Positioning the PIP, Limitations

PICTURE IN PICTURE

7.1.Introduction

To enable PIP mode, scroll down the main menu to the Picture-in-Picture Settings menu and press the right navi-key to enter that menu. To enable PIP, scroll to the PIP Enable option and press the OK key. Note: You cannot use the PIP menu successfully without at least two active inputs connected to Vantage-HD.

Selecting the input	Use the PIP Inputs menu to select which picture is displayed in the
	PIP window
Swapping PIP	Use the PIP Swap function to swap the primary image with the PIP
	image
	Use the PIP Position function to chose the location of the PIP
	image from
Positioning the PIP	Top Left
	Top Right
	Bottom Left
	Bottom Right
	When the PIP is displayed and the OSD menu is not on screen
OSD not visible	the navi-key arrows can be used to move the PIP around the
	screen and re-size the PIP window
	PIP Limitations - due to the high demands on the processing
	power available within the Realta HQV chip when a HD main
	image is displayed, full Teranex Video Processing is not always
	available when PIP is in use.
	If the main image is 1080i or 1080p and the PIP image is 720p,
Limitations	1080i or 1080p the maximum available image processing
	bandwidth may be exceeded. In such circumstances Teranex
	Video Processing is automatically disabled resulting in reduced
	image quality. Full image processing performance and quality is
	automatically restored when the PIP is closed.
	If the main image or the PIP image are SD then full Teranex Video
	Processing is maintained even with a PIP showing.

Issue 1.0.2 28 March 2006 © Calibre UK Ltd Page 16 of 30