JVC RM-P210 manual Intercom, Camera Operator Call, Tally Input, Rear panel, Front panel

PREPARATIONS AND MAIN FUNCTIONS

INTERCOM

Intercommunications between operators are necessary in a system composed of multiple cameras and remote control units.

Rear panel

	TALLY			INTERCOM	AUX VIDEO INPUT	G
PGM	PVW	C	H	C	G
					RTS

Front panel	INTERCOM LEVEL control
	TALLY	CALL	FULL AUTO	F1
				SHUTTER
				2. CABLE
			BARS	F2
				GAIN
		INTERCOM
		LEVEL

The intercom employs the RTS system.

If it is required to change this to a 2-wire system, consult your nearest JVC-authorized service agent. (The modification will then be carried out with charge.)

An intercom jack is provided on the front panel of the RM-P210.The volume level of the headset’s earphone can be adjusted using the INTERCOM LEVEL control.

NOTE

●Examples of suitable headsets

JVC KA-310(Microphone 50 W/DC, earphone 150 W/1kHz) Headsets from other manufacturers with:

Microphone output impedance: 50 W to 100 W

Earphone input impedance: 50 W to 300 W

● The RM-P210 has been set at the factory to be compat- ible with a dynamic type headset. If it is required to use a

Intercom jackcarbon type headset, the setting of the internal circuitry should be changed; consult your nearest JVC-authorized service agent. (The modifications and adjustments will be carried out with charge.)

CAMERA OPERATOR CALL

This function makes it possible to call the camera operator without using the intercom. The camera operator is informed of the call by the blinking of the tally lamp on the camera.

TALLY CALL FULL AUTO F1

	SHUTTER
	2. CABLE
BARS	F2
	GAIN
INTERCOM
LEVEL

CALL button

When the CALL button is pressed, the button lamp is lit and the tally lamp on the camera blinks. Pressing the button again turns off both the button lamp and the blinking of the camera’s tally lamp.

NOTE

The tally lamp on the camera does not blink or light when either the camera or the RM-P210are switched off. When the CALL button of the camera is pressed, the TALLY lamp of RM-P210 blinks in red.

TALLY INPUT

The TALLY lamp on the front panel lights when signals are applied to the TALLY input terminals on the rear panel.

	TALLY			INTERCOM	AUX VIDEO INPUT	G
PGM	PVW	C	H	C	G
					RTS

C (Common) terminal

PVW (Preview) terminal

PGM (Program) terminal

●The TALLY lamp lights in red when contact is made be- tween the PGM (Program) and C (Common) terminals.

●The TALLY lamp lights in green when contact is made be- tween the PVW (Preview) and C (Common) terminals.

NOTE

The RM-P210 has been set at the factory in the “make con- tact mode”. If it is required to set it to the “voltage supplied mode”, the setting of the internal circuitry should be changed; consult your nearest JVC-authorized service agent. (The modification will then be carried out with charge.)

14