Rear panel

INTRODUCTION

CONTROLS, CONNECTORS AND INDICATORS (CONTINUED)

	TALLY			INTERCOM		AUX VIDEO INPUT	GENLOCK INPUT		VIDEO OUTPUT	Y/C OUT
PGM	PVW	C	H	C	G		R/R-Y	G/Y	B/B-Y
						RTS			COMPOSITE VIDEO	CAMERA CABLE
						RTS

1	2	3	4	5	6	7	8	9
1 [AC ` IN] connector				7 [COMPOSITE VIDEO] signal output connectors

Connect this socket to a commercial power supply outlet using the power cord provided.

These terminals output two lines of VBS (composite video) signals.

2[TALLY] terminals

These terminals input the tally signals.

●When the contact between the PGM (Program) and C (Common) terminals is closed, the TALLY lamp 3 on the front panel lights in RED.

●When the contact between the PVW (Preview) and C (Common) terminals is closed, the TALLY lamp 3 on the front panel lights in GREEN.

REF. : “Tally Input” on page 14.

3[INTERCOM] terminals

These terminals input and output the intercom signals. In a system composed of multiple cameras and remote control units, the intercom function provides intercommu- nication between operators.

REF. : “Intercom” on page 14.

4[AUX VIDEO INPUT] connectors

These connectors are used to input the return video sig- nal, which returns the SEG (Special Effects Generator) or switcher output signal to the camera viewfinder.

The two terminals are loop-through connected inside to enable a bridge connection.

They are terminated automatically when they are not bridge-connected.

5[GENLOCK INPUT] connectors

These connectors are used to input the VBS/BB signal for use in genlocking.

They are terminated automatically when they are not bridge-connected.

6[R/R-Y, G/Y, B/B-Y] component video signal output connectors

The settings of the output signals from these connectors can be switched between RGB, R-Y/Y/B-Y and Y/C using the SIG SELECT switch on the camera adapter or by us- ing the menu setup of the camera.

When Y/C is selected, the Y signal is output from the G connector and the C signal is output from the R connector.

8Y/C OUT connector (4-pin)

This connector outputs the separate Y/C video signals.

NOTE

This connector outputs Y/C signals only when Y/C is selected as the output from the R/R-Y, G/Y and B/B-Y connectors 6.

9[CAMERA CABLE] connector (26-pin)

Connect this socket to a camera using the optionally avail- able camera cables.

Camera Cables (Optional)

The VC-P110series camera cables that can be used to con- nect a camera to the RM-P210are available in four lengths as listed below.

VC-P110 : 5 meters

VC-P112 : 20 meters

VC-P113 : 50 meters

VC-P114 : 100 meters

A menu setup is required according to the cables in use.

REF. : “Setup of Camera Cable Length” on page 12.