JVC RM-P210 manual General, Error Messages

GENERAL

WARNING MESSAGES

To prevent operational errors, the LCD display shows one of the following warning messages when an erroneous operation is performed.

Displayed Message	Cause	Check Point
INVALID ENTRY	The gain is set to the LoLux mode.	Exit from the LoLux mode, and then
GAIN : LOLUX		adjust the gain again.
INVALID ENTRY	The FULL AUTO button is ON.	Press the FULL AUTO button so that
FULL AUTO : ON		the lamp in it turns off, then retry
		operation.
INVALID ENTRY	ACC+EEI is ON.	Exit from the ACC+EEI mode, and then
GAIN : ALC + EEI		retry operation.
INVALID ENTRY	The white-balance is set to the FAW	Cancel FAW and start the white-balance
W.BAL : FAW	mode.	adjustment.
INVALID ENTRY	The W.BAL button is set to PRESET.	Auto white balance adjustment cannot
W.BAL : PRESET		be started in this mode.
INVALID ENTRY	The white balance adjustment is set to	Auto white balance adjustment cannot
W.BAL : MANUAL	manual mode by the AUTO/MANU button.	be started in this mode.
INVALID ENTRY	The BARS button is pressed.	Press the BARS button so that the
BARS : ON		lamp in it turns off, then retry operation.

ERROR MESSAGES

When the LCD display shows one of the following error messages during an auto white balance adjustment and AUTO SET mode, check “Cause” and “Check Point” below and then retry the auto white balance adjustment. (The error message is displayed for about 5 seconds.)

Displayed Message	Cause	Check Point
AUTO WHITE A (B)	The light intensity is insufficient.	Increase the lighting (illumination) or
ERROR: LOW LIGHT		boost the gain with the GAIN button.
		(Note that the sensitivity deteriorates
		when the gain is boosted.)
AUTO WHITE A (B)	The object is not suitable for shooting.	Check if the object is white and change
NG: OBJECT		the object if required.
AUTO WHITE A (B)	● The amount of incident light is too high.	● Check if a strong light source, such as
ERROR: OVER LIGHT		the sun, is shining into the camera ei-
		ther directly or as a result of a reflec-
		tion caused by the object.
	● The color temperature conversion fil-	● Set the color temperature conversion
	ter is not set properly.	filter to the correct position.
AUTO BLACK LENS NOT CLOSED?	The lens will not close for auto black-bal-	Set the camera so that the lens can be
	ance adjustment.	closed.
AUTO BLACK ERROR!	Auto black adjustment is not working	Check the setups of the RM-210 and
	properly.	camera again.

28