JVC SR-MV45U, SR-MV55U Edit From a Camcorder, If the camcorder has no S-VIDEO output connector

52 EN EDITING

	Edit From A Camcorder	Slide the TV/CABLE/DBS/DVD switch to DVD.
		1 Make connections.
You can use a camcorder as the source player and your unit as the
		A If the camcorder has no S-VIDEO output connector:
recording deck.
		— connect the camcorder’s Audio/Video output connector to the

A If the camcorder has no S-VIDEO output connector:				unit’s [AUDIO IN F-1] and [VIDEO IN F-1] input connectors on the
				front panel.
				● When using a monaural camcorder, connect its AUDIO OUT
				connector to the [AUDIO L] input connector on your unit.
				B If the camcorder has an S-VIDEO output connector:
				— connect the camcorder’s Audio/Video output and S-Video
				output connectors to the unit’s [AUDIO IN F-1] and [S-VIDEO IN
				F-1] connectors on the front panel.
			Recorder	2 Press VCR/DVD repeatedly to select the recording deck.
To	To [AUDIO IN F-1]			3 Press INPUT SELECT +/– on the unit or INPUT +/– on the
[VIDEO				remote control to select “F-1”.
IN F-1]				● Set “FRONT AUX F-1” to “VIDEO” for the [VIDEO IN F-1] connector,
				or “S-VIDEO” for the [S-VIDEO IN F-1] connector, depending on the
	Audio/Video cable			connector being used. ( pg. 59) This setting is also applied to the
				VCR deck.
	(not supplied)
				4 For VCR deck only
				Set “PICTURE CONTROL” to the appropriate mode. ( pg. 61)
				5 Press REC MODE repeatedly to set the recording mode.
				( pg. 36)
				6 Start playback on the camcorder slightly before the actual point
	To Audio/Video Player			from where you wish to start dubbing.
				For VCR deck only
	output
				Press 7 and 9 simultaneously to set to record pause mode.
				7 Press 7 on the unit to start recording. Or while holding 7, press
				4 on the remote control. The dubbing starts.
B If the camcorder has an S-VIDEO output connector:				For VCR deck only
				After about 10 seconds, press 4 to start recording.
				8 Press 8 on the unit, then stop playback on the camcorder.
				NOTES:
				● All necessary cables can be obtained from your dealer.
				● Refer to the camcorder’s instruction manual for operating procedure.
				● The quality of dubbed picture becomes poorer than that of the
				original.
				● When you select “EDIT” to dub tapes in step 4, be sure to select
				“AUTO” (or “NORM” when “VIDEO CALIBRATION” is set to “OFF”)
To [S-VIDEO	To [AUDIO IN F-1]		Recorder	after you finish dubbing the tapes.
IN F-1]
	Audio/Video cable (not supplied)
	To Audio/Video
	output
	S-Video cable
	(supplied)
	To S-Video output	Player