JVC SR-MV55U, SR-MV45U manual When using this unit as the recording deck

EDITING EN 53

	Edit To Or From Another Recorder	Slide the TV/CABLE/DBS/DVD switch to DVD.
		1 Make connections.
You can use your unit as the source player or as the recording
		When using this unit as the recording deck
deck.
		A If the another recorder has no S-VIDEO connector, connect the

NOTE:	unit’s [AUDIO/VIDEO INPUT] connectors to the audio/video output
When using another recorder as the recording deck, refer to its	connectors on another recorder.
instruction manual.	B If the another recorder has S-VIDEO connector, connect the
	[AUDIO INPUT] and [S-VIDEO INPUT] connectors to the audio
Your unit	and S-video output connectors on another recorder.
	● If connecting a unit with an S-VIDEO connector, it is recommended to
	use the supplied S-Video cable to minimize picture degradation while
	editing.
Recorder	2 Press VCR/DVD repeatedly to select the recording deck.
	3 Press INPUT SELECT +/– on the unit or INPUT +/– or AUX on
TV receiver
	the remote control to select “L-1” when using this unit as the
	recording deck.
	● Set “REAR AUX L-1” to “VIDEO” for the [VIDEO INPUT] connector,
	or “S-VIDEO” for the [S-VIDEO INPUT] connector, depending on the
	connector being used. ( pg. 59) This setting is also applied to the
	VCR deck.
	4 For VCR deck only

Another recorder

Player

Set “PICTURE CONTROL” to the appropriate mode. ( pg. 61)

5 Press REC MODE repeatedly to set the recording mode. ( pg. 36)

6 Engage the Play mode of the source player.

For VCR deck only

Press 7 and 9 simultaneously to set to record pause mode. 7 Engage the Record mode of the recording deck.

For VCR deck only

After about 10 seconds, press 4 to start recording.

8 Stop recording on the recording deck, then stop playback on the source player.

NOTES:

●All necessary cables can be obtained from your dealer.

●When you use this unit as the source player for editing, be sure to set “SUPERIMPOSE” to “OFF” before starting. ( pg. 59)

●When you select “EDIT” to dub tapes in step 4, be sure to select “AUTO” (or “NORM” when “VIDEO CALIBRATION” is set to “OFF”) after you finish dubbing the tapes.