JVC LPT0923-001A manual Manual Timer Programming, Relief Recording

46 EN TIMER RECORDING

Manual Timer Programming

You can programme this unit to timer-record as many as 32 programmes.

If you do not know the SHOWVIEW number for the programme you wish to record, use the following procedure to set your unit to timer-record the programme.

●Make sure that the unit’s built-in clock is set properly.

●Turn on the unit.

●Turn on the TV and select the AV mode.

●Slide the TV/CABLE/SAT/DVD switch to DVD.

6 Press rt to select “START”, then press ENTER. Press rt to set the desired start time, then press ENTER.

●Each press of rt advances/goes back the start time in 1-min. increments.

●To advance/go back the start time in 30-min. increments, press and hold rt.

7 Press rt to select “STOP”, then press ENTER. Press rt to set the desired stop time, then press ENTER.

●Each press of rt advances/goes back the stop time in 1-min. increments.

●To advance/go back the stop time in 30-min. increments, press and hold rt.

8Press rt to select “TV PROG”, then press ENTER. Press rt to select the desired channel.

CABLE/SAT

TVDVD

9Press rt to select “CONFIRM”, then press ENTER.

10Set the other recording options as required.

●Refer to step 8 in “SHOWVIEWTM Timer Programming” ( pg. 44).

11 Press rt to select “OK”,	2 PROGRAMME > CALENDAR PR. (3/3)
then press ENTER to access the
	14/01/04 WED 22:30 - 23:00		BBC1
Programme Confirmation screen.	GARDENING	[EDUCATION] FR360
		1:00	28:00

AUX	PROGRAMME
ENTER
	rtwe

12 Press w e to select “EXIT”, then press ENTER to complete timer programming.

●To programme another timer, press w e to select “CONTINUE”, then press

ENTER.

SELECT WITH [ ] THEN PRESS [ENTER]

PRESS [PROGRAMME] TO EXIT

PROGRAMME ENTER

EXIT SELECT

INPUT TITLE	GARDENING
CATEGORY	EDUCATION
VPS/PDC	OFF
WEEKLY/DAILY	MON-FRI (FOR A WEEK)
REC MODE	FR360
	O K

1 Load a recordable disc if recording to DVD.

2 Press PROGRAMME to access the programme top screen.

3 Press rtw e to select “CALENDAR PR.”, then press ENTER.

●When “PROGRAMME FULL DELETE UNWANTED TIMER PROGRAMMES” appears on the TV screen, you need to cancel some of the reserved programmes. ( pg. 47)

4 Press rtw e to select the desired date, then press ENTER.

5 Press rt to select “RECORD				PROGRAMME > CALENDAR PR. (2/3)
		2
TO”, then press ENTER. Press
			14/01/04 WED 22:30 - 23:00		BBC1
rt to select the desired					[MISC. ] XP
recording deck, then press
	SELECT WITH [ ]			RECORD TO	HDD
ENTER.	THEN PRESS [ENTER]
				START	22:30
	PRESS [PROGRAMME]
				STOP	23:00
	TO EXIT
	[0]: SAT			TV PROG	BBC1

PROGRAMME ENTER

CONFIRM

EXIT SELECT

●If “PROGRAMME OVERLAPPED” appears on the TV screen, see page 47.

NOTES:

●When two successive programmes are recorded on a DVD-RW disc with Manual Timer Programming function, the beginning of the second one may be left off the recording.

●If the copy limited programme is received during timer-recording, the unit enters Record Pause mode. Recording starts again if it is switched to a recordable broadcast during the time you programmed.

Satellite Receiver Users

To timer-record a satellite broadcast using Manual Timer Programming:

APerform “Satellite Receiver Control Setting” ( pg. 23).

BPerform “Manual Timer Programming” ( pg. 46). In step 8, press AUX to change “TV PROG” to “SAT”. Then press rt to enter the channel position for the satellite broadcast.

C Leave the satellite receiver’s power on.

Relief Recording

When a programme that is set for the DVD deck cannot be recorded properly, the programme is recorded to the HDD deck instead in the same recording mode as set.

●If the remaining capacity of the hard disc is not sufficient, the programme is recorded to the DVD deck until the remaining capacity of the DVD disc lasts.

●If “JUST” is selected for the recording mode, the current recording mode for the DVD deck is applied.