3M S55, X45, X55 manual Option Menu, Search, Auto OFF, Lamp Time, Reset  Cancel

Multifunctional settings

OPTION Menu

With the OPTION menu, items shown in the table below can be performed.

Select an item using the cursor buttons ▲/▼ on the projector or remote control, and press the cursor button ► on the projector or remote control, or the ENTER button on the remote control to progress, except for the items LAMP TIME and FILTER TIME. Then perform it referring to the following table.

MENU [RGB]		:SELECT
PICTURE	SEARCH	TURN ON
IMAGE	AUTO OFF	0
INPUT	LAMP TIME	0
SETUP	FILTER TIME	0
SCREEN	SERVICE
OPTION
EASY MENU

Item

Description

	Using the buttons ▲/▼ turns on/off the automatic signal search
	function.
	TURN ON  TURN OFF
SEARCH	When the TURN ON is selected, detecting no signal automatically
	cycles through input ports in order of following. Then when an input
	is found, the projector will stop searching and display the image.
	RGB IN1  RGB IN2  COMPONENT VIDEO  S-VIDEO  VIDEO
	Using the buttons ▲/▼ adjusts the time to count down to
	automatically turn the projector off.
	Long (max. 99 minutes)  Short (min. 0 minute = DISABLE)
	AUTO OFF	AUTO OFF
	ENABLE	DISABLE
AUTO OFF	1	0
	When the time is set to 0, the projector is not turned off
	automatically.
	When the time is set to 1 to 99, and when the passed time with
	a no-signal or an unsuitable signal reaches at the set time, the
	projector lamp will go off and the power indicator begins blinking.
	Please refer to the section “Turning off the power” (17).
	The lamp time is the time counted after the last resetting. It is
	shown in the OPTION menu as the use time of the lamp.
	Pressing the RESET button on the remote control for about 3
	seconds displays a dialog. To reset the lamp time, select the
LAMP TIME	RESET using the button ▲.
	RESET  CANCEL
	• Please reset the lamp time only when you have replaced the lamp,
	for correct messages about the lamp.
	• About the lamp replacement, please see the section "Lamp" (
	39, 40).

37