3M S55, X45, X55 manual Part names, Projector, Cb/Pb Cr/Pr

Part names

Part names

Projector

Remote sensor (16)

Zoom knob (19) Speaker

Focus ring (19)

Vent (6)

Lens (17)

Lamp door

Front-Right side

Elevator button (8)

Elevator foot (8)

41

(Lamp unit is inside.) (39)

Bottom side

Control buttons (See the following page.) (5)

Filter cover ( )

(Air filter and intake vent are inside.)

Power switch (17) AC inlet (14) Elevator button (8)

Ports

(See below.)

AUDIO OUT port (12) AUDIO IN1 port (12) S-VIDEO port (13)

COMPONENT VIDEO ports (13)

Y

CB/PB

CR/PR

VIDEO port (13) AUDIO IN2 port (12) USB port (22)

Rear-Left side

	audio in1
Y
	audio out	rgb in1	rgb in2
CB/PB
video	audio in2
CR/PR S-video	USB
component video
		control

Ports

Elevator foot (8)

Vent (6)

Restart switch (*) (47) RGB IN1 port (12) RGB IN2 port (12) RGB OUT port (12)

rgb out

CONTROL port (12)

Kensington lock slot

NOTE (*) About Restart switch: This Projector is controlled by an internal microprocessor. Under certain exceptional circumstances, the projector may not operate correctly and the microprocessor will need to be reset. In such a case, please push the Restart switch by using a cocktail stick or similar and before turning on again, make the projector cool down at least 10 minutes without operating. Only push the Restart switch in these exceptional instances.

4