Securing the mounting brackets
DIMPLES
M5
M4
Phillips screw
driver
DIMPLES
FACING UP
M8 
M6
The Griplates™ have M4, M5 M6 and M8 hole patterns to fit the hardware that your flat panel requires.
EXAMPLE: If your plasma uses M8 x 20 Phillip screws. Use the M8 mounting points. See figure 7
Pre install two (2) M6 x 30 (mm) Phillip pan screws to the bottom of the left and right hand side mounting brackets. Once the mounting brackets are aligned secure the Griplate™ to the flat panel.
NOTE: The dimples of the top plates have to be facing up and the bottom dimples must be facing down.
Use (1) Griplate™ per mounting point. See figure 8.
DIMPLES
FACING UP
DIMPLES | Bottom of flat |
FACING DOWN | panel |
DIMPLES
FACING DOWN
NOTE: Secure the two (2) M6 x 30 Phillip pan screws to the left and right mounting bracket.
CAUTION: Do not over tighten the mounting
hardware.
- 13 -