Checking the thread depth on your flat panel
1.Insert the thread depth indicator (supplied) through the thread inserts found on the back of the flat panel to make sure the inserts measure the same full depth and mark it. (see figure 1)
2.Locate the correct diameter screw for the thread insert. Compare your marking to the screws (supplied). If your selected screw is longer than the marking on the thread depth indicator DO NOT USE this screw.
The screw length must not bypass the marking. Select another screw size
(see figure 2 and 3). Until you find one that comes closest to your mark without going past.
Figure 2
Figure 3
Figure 1
Inverted flat panel
display
Marking the depth
Thread insert
Thread depth
indicator
Screw
Marking
Thread depth indicator
Screw
Marking
- 8 - | Thread depth indicator |
|