Hitachi LE22S314 Antenna connections, Cable TV connections, Ohm Cable to TV Jack, ohm Antenna

Page 12

Antenna connections

If you are using an indoor or outdoor antenna, follow the instructions below that correspond to your antenna system. If you are using a Cable TV service, see Cable TV connections.

Combination VHF/UHF Antenna (Single 75 ohm cable)

Antenna

Connect the 75 ohm cable from the combination VHF/UHF antenna to the antenna jack.

Jack

 

75 ohm Coaxial Cable

Cable TV connections

This TV has an extended tuning range and can tune most cable channels without using a Cable TV Converter box. Some cable companies offer “premium pay channels” where the signal is scrambled. Descrambling these signals for normal viewing requires the use of a descrambler device which is generally provided by the Cable TV company.

For subscribers to basic Cable TV service

For basic Cable TV service not requiring a Converter/Descrambler box, connect the

Antenna 75 ohm Coaxial Cable directly to the Antenna Jack on the back of the TV. Jack

75 ohm Coaxial Cable

For subscribers to scrambled Cable TV service

 

 

If you subscribe to a Cable TV service which requires the use of a Converter/Descrambler box, connect the incoming 75 ohm Coaxial

Cable to the Converter/Descrambler box. Using another 75 ohm Coaxial Cable, connect the output jack of the Converter/Descrambler

box to the Antenna Jack on the TV. Follow the connections shown below. Set the TV to the output channel of the Converter/Descrambler

box (usually channel 3 or 4) and use the Converter/Descrambler box to select channels.

 

 

 

 

Antenna

Incoming 75 ohm Cable TV Cable

Converter/

75 ohm Cable to TV

Jack

 

 

Descrambler

 

 

For subscribers to unscrambled Cable TV service with scrambled premium channels

If you subscribe to a Cable TV service in which basic channels are unscrambled and premium channels require the use of a Converter/ Descrambler box, you may wish to use a signal Splitter and an A/B Switch box (available from the Cable TV company or an electronics supply store). Follow the connections shown below. With the switch in the “B” position, you can directly tune any nonscrambled channels on your TV. With the switch in the “A” position, tune your TV to the output of the Converter/Descrambler box (usually channel 3 or 4) and use the Converter/Descrambler box to tune scrambled channels.

Incoming

 

Converter/

 

 

 

75 ohm

 

 

 

Antenna

 

Descrambler

 

 

Cable TV

 

 

 

75 ohm Cable to TV

Jack

Cable

Splitter

A/B Switch

A

 

 

B

 

IMPORTANT NOTICE

The nationwide switch to digital television broadcasting will be complete on June 12, 2009, but your local television stations may switch sooner. After the switch, analog-only television sets that receive TV programming through an antenna will need a converter box to continue to receive over-the-air TV. Watch your local stations to find out when they will turn off their analog signal and switch to digital-only broadcasting.

Information about the DTV transition is available from your local television stations, www.DTV.gov, or 1-888-CALL-FCC (TTY 1-888-TELL-FCC), and www.dtv2009. gov or 1-888-DTV-2009 (TTY 1-877-530-2634) for information about subsidized coupons for digital-to-analog converter boxes. Please review this Operating Guide for further information regarding such connections.

Hitachi supports the DTV transition and as a member of the DTV Transition Coalition urges consumers to visit these web sites for interactive guides and further detailed information:

• www.dtvtransition.org

• www.myceknowhow.com

• www.dtv2009.gov

12

Image 12
Contents Page Location of the required Marking Energy StarImportant Safety Instructions Power source HOW to Handle the LCD PanelDeclaration of Conformity CondensationChild Safety Notice Safety Precautions Securing to a WallHow to attach the stand How to remove the standFeatures Power sourceTo USE AC Power Contents Before using your unitLocation of controls Left sideFront Right sideRemote control Battery PrecautionsCH Channel / Buttons Press to change Channels of the LED TVCable TV Ohm Cable to TV Jack Splitter Switch Antenna connectionsCable TV connections Ohm Cable to TV JackTo select the video input source To Select Analog ChannelsTo Select Digital Channels EnterQuick guide for menu operation Example Select LanguageIcon Selected Items Setup hint Convenience functionsMemorizing channels Checking the digital signal strength Setting the Parental ControlLabeling channels Labeling video inputsTo change the password To set the Parental ControlDownloading the additional Parental Control rating system Aspect Switching Closed CaptionCC advanced Opacity FlashingNative for PC mode only NaturalCinema Wide1 for 43 format programs Cinema Wide2 for letter box programsConnections to other equipments To connect the unit to a VCRVCR DVDUsing an AV Amplifier with built-in digital surround To connect a Hdmi or a DVI device to the unitLeft side of the unit Rear of the unit To return to normal mode Press Input Select again To connect the unit to a camcorder or game consoleRear of the unit Left side of the unit Monitor Display modesReception disturbances Troubleshooting Symptoms Possible SolutionsSpecifications AccessoriesGeneral TelevisionOrion SALES, INC 3471 N. Union DREspañol Lugar de la marca requeridaInstrucciones DE Seguridad Importantes Electrodo de tierraFuente de Energía AdvertenciaPrecaución Declaración de ConformidadAviso DE Seguridad Para Niños Notas para el montaje en la LED TV Asegurar a una paredInformación Para EL Mueble DEL Televisor AdvertenciaCómo instalar el soporte Cómo quitar el soporteNota Características Fuente de alimentaciónLED TV a Color Para Usar LA Alimentación CAIndice Antes de utilizar su aparatoUbicación de los controles Lado izquierdoDelantera Lado derechoControl remoto Cómo Instalar LAS PilasConexiones de la antena Conexiones de TV por cableDe TV por cable El aparato Cable entrantePara Seleccionar Canales Analógicos Para Seleccionar Canales DigitalesCanales DE VHF/UHF/CABLE Aire CableGuía rápida para el manejo de menú Ejemplo Seleccionar LanguageOtras funciones prácticas Icono Elementos seleccionados Consejo de confi guraciónMemorización de canales Selección de Air/CableProgramar Canales Comprobación de la intensidad de la señal digital Ajuste del ParentalPara crear etiquetas de canal Para eliminar una Channel Label etiqueta de canalPara ajustar el Parental Control Para cambiar la contraseñaConfiguración del tamaño de la imagen Cambio de aspectoSeleccionar Video, luego presione o Enter Tamaño de imagen Natural Cinema Wide2 para programas letter boxFull para programas en formato Native solo para el modo de PCConexiones a otros equipos Conexión del unidad a un VCRLado izquierdo del unidad Para conectar el unidad a un Hdmi o a un dispositivo DVI Lado izquierdo del unidad Parte trasera del unidadConexión del unidad a una videocámara o a un juego de vídeo Parte trasera del unidad Lado izquierdo del unidadModos de visualización del monitor Para volver al modo normal Vuelva a pulsar Input SelectDisturbios de recepción Solución de problemas Síntoma Posible SoluciónEspecificaciones GeneralidadesTelevisor AccesoriosGarantia Limitada Memo Memo J3AV0621A SH 10/08