Programming the Polaroid Universal Remote Control
Following are two sets of instructions for programming your Polaroid Universal Remote Control to work with other devices in addition to your Polaroid TV. (If you only wish to use
the remote control with your Polaroid TV, no additional programming is necessary.) Begin with the Direct Programming Setup, and if unsuccessful, go on to the Auto Code Search Setup.
Direct Programming Setup
This method requires use of one of the device codes found in the Device Code Table
(see last paqes of your Operatinq Manual). Begin with the first code listed for your device.
1 Turn the device power off and point the Polaroid Universal Remote Control at the device you wish to control.
2 Momentarily press a device button on the Polaroid Universal Remote Control (TV, DVD, CBL, or AUX). When you release the device button the red LED at the top of the remote will blink once.
Note: For devices other than a TV, DVD, or Cable Box, use the AUX key.
3 Press and hold the SET button
4 Enter the
a)If the code you entered is the correct code for your device, you will see the LED blink twice. Go to step 5.
b)If the code you entered is not the correct code for your device, you will see the LED blink once. Repeat steps
5 Press the Power button (top
If you are unable to program the remote properly after two or more attempts using the Direct Programming Setup, go on to the Auto Code Search Setup.
42