Extron electronic DVS 406 AD manual Front Panel Features, Input selection buttons, Take button

Front Panel Features

The front panel buttons, controls, and LCD of the DVS 406 AD model, as shown below, are found on all models of the DVS 406 scaler series. The LEDs above each button will light green when the button is pressed.

1	2	3	4	5	6		PICTURE ADJUSTMENTS		MENU	ADJUST
RGB	RGB/YUV	VIDEO/	VIDEO/	VIDEO/	SDI	TAKE	COL/TNT BRT/CONT DETAIL	SIZE	CENTER	DVS 406
		S-VIDEO	S-VIDEO	S-VIDEO					NEXT
										DIGITAL VIDEO SCALER

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18

DVS 406 AD front panel

1Infrared sensor — This sensor is used to receive infrared (IR) signals from the IR-901 remote control. See the “IR 901 Infrared Remote Control” section in this chapter.

Input selection buttons

2RGB input button — This button selects the pass-through RGB computer video or HDTV component video input.

HDTV component video input will be output as RGB.

3RGB/YUV input button — This button selects the RGB computer video or component video input.

4 5 6

7

Video/S-video input buttons — These buttons select from the composite or S-video inputs.

SDI input button (serial digital interface) — This button selects the SDI input 6 (available only on DVS 406 AD and DVS 406 D models).

If the audio module is installed and the SDI card is not installed, input 6 will be audio-only and the video output will be a black display.

Take button

8Take button — When this button is enabled through the menu system, selecting an input selection button ( 2 thru 7 above) followed by pressing the Take button, will cause a switch to the new input to occur. If the Take button is not enabled, the switch to a selected input will automatically occur when the input button is pressed.

Picture adjustment buttons

These buttons have no effect on the pass-through inputs (inputs 1 and 2).

9Color/Tint control button (Col/Tnt) — This button controls the color and tint adjustment on the display by using the horizontal Adjust and vertical Adjust adjustment knobs. The adjustment range of both color and tint is 0 to 255. See the “Image adjustments” section in this chapter.

The tint control is only available if the input is composite or S-video.

10Brightness/Contrast control button (Brt/Cont) — This button controls the brightness and contrast adjustment on the display by using the horizontal Adjust and vertical Adjust adjustment knobs. The adjustment range of both brightness and tint is 0 to 255. See the “Image adjustments” section in this chapter.

DVS 406 • Installation and Operation 2-7