Extron electronic DVS 406 D, DVS 406 AD manual Memory Presets, Audio Level, Audio Switch

Extron

DVS 406

MENU

Input

Configuration

MENU

Output

Configuration

MENU

Audio

Configuration

NEXT	Audio #6 Level	NEXT	Audio Switch		NEXT
	0.0 dB			Start
Audio level			Audio switching effects
•	-15 dB to +9.0 dB in 1 decibel		•	Start (default)
	increments (-15 dB default)		•	Middle
			• End

NOTE

• Fade

Audio Level

From this submenu, audio levels can be adjusted per input from -15 dB to +9 dB in 1 dB increments. This allows the signal to be boosted or trimmed to a consistent output level so that there is no noticeable difference in level when switching between inputs.

Using either the horizontal Adjust () or vertical Adjust () knob, select the proper level of audio for the given input.

Audio Switch

When the video input signal is being switched, there are four methods for switching the audio:

•Start — switches to the next audio input at the beginning of the next video input.

•Middle — switches to the next audio input halfway into the next video input.

•End — switches to the next audio input at the end of the next video input.

•Fade — gradually mutes the current audio halfway between the switch to the new video input , then gradually increases the next audio input from mute.

Use either the horizontal Adjust () or vertical Adjust () knob to select the desired audio switching effect.

Memory Presets

The following flowchart provides an overview of the Memory Presets submenus and the options for each setting.

The presets will only save the Sizing and Centering information, and not for the pass-through inputs, i.e. input 1 and RGBp from input 2.

DVS 406 • Installation and Operation 2-13