Extron electronic DVS 406 D manual Pin socket on back of audio card Pin connector on main board

Page 52

Appendix, cont’d

6.The audio card has a 20-pin socket on the underside which should align with the 20 pins on the main circuit board. Be sure to align the pins properly, in order to prevent bending the pins, before pressing the audio card firmly in place against the standoffs. The four mounting holes on the audio card should now be directly over the standoffs.

20-pin socket on back of audio card

20-pin connector on main board

7.Insert the four installation screws through the audio card’s mounting holes and gently tighten them into the standoffs.

8.Replace the top cover on the DVS 406 scaler, and fasten it with the screws that were removed in step 3.

9.Rack/furniture mount the scaler, connect the input/output cables, then reconnect the AC power cord.

A-8 DVS 406 • Appendix

Image 52

Contents DVS Safety Instructions English Consignes de Sécurité FrançaisSicherheitsanleitungen Deutsch Instrucciones de seguridad EspañolRear panel video inputs Rear panel audio inputsRear panel video output Rear panel audio outputDefault Cycle menu Main menuInput menu Output menuAudio Configuration menu Memory Presets menuAdvanced Configuration menu DVS 406 Quick Start QS-3Picture Adjustments menu Executive Mode menuExit menu QS-4 DVS 406 Quick StartTable of Contents Table of Contents, cont’d One What is the DVS 406? About this ManualAbout the DVS Controlling the DVS 406 digital video scalerFeatures and Options FeaturesOptions and accessories Introduction, cont’dInstallation and Operation DVS 406 Installation and Operation Mounting the ScalerTabletop use Rack mountingApplication diagram Extron DVSRear Panel Features DVS 406 AD rear panel connectorsOnly DVS 406 D and DVS 406 AD models have an SDI connector Installation and Operation, cont’d Front Panel Features Picture adjustment buttonsInput selection buttons Take buttonOptimizing the System Setting up a DVD sourceLCD menu display and controls Moving through menus by using front panel controls Menus, Configuration, and AdjustmentsMenu overview Input Configuration Output Configuration Resolution and refresh ratesInput Video Type #1 Input Video Type #2 and #3Audio Configuration Available Scaler Output Resolutions and Rates 50 Hz56 Hz 60 Hz 75 Hz Lock @ 50/60 True 72/100 Output Sync RGB formatAudio Switch Memory PresetsAudio Level Clear memory presets Save Save memory presetsRecalling a preset Advanced Configuration Top and bottom blanking blanking adjustmentEffect type Edge smoothingRGB delay Triple-Action Switching Switch modeBlue mode Key modeImage Adjustments Pulldown detection PAL film mode detectReset Exit MenuAdjust knobs have no mechanical limits to their rotation Front Panel Security LockoutIR 901 Infrared Remote Control Selecting a presetSelecting an input Freezing an inputTroubleshooting Operating ProblemsDVS 406 Installation and Operation Installation and Operation, cont’d Three Error responses RS-232 Programmer’s GuideHost-to-scaler communications Scaler-initiated messagesUsing the command/response tables Symbol definitionsCommand Ascii Command Response Additional description Serial Communication, cont’dTint Top blanking Command Ascii Command Response ValuesUsing the control program Installing the softwareControl Software for Windows Using the help program Serial Communication, cont’d AAppendix Specifications DVS 406 AppendixAudio Part Numbers and Accessories AccessoriesAccessories Part number Included partsFirmware Upgrade Installation Remove 13 screws from top and sides Lift Cover Straight UpU41 Audio Card Installation Audio card standoffsPin socket on back of audio card Pin connector on main board Serial Digital Interface SDI Card Installation SDI connector opening SDI card standoffPin socket on back of SDI card Pin connector on main board FCC Class a Notice Extron’s Warranty Extron Electronics, USA