Explanation of the Settings menu items

LUC:

LUC is short for Luminance Uniformity Control. When switched on, the internal waveform processor will modulate the gain of the video amplifier so that the luminance is equal all over the screen (within a tolerance of +/- 5%).

The LUC system can be calibrated in the Adjustments menu (see further).

ALC (optional):

ALC is short for Ambient Light Compensation. When this setting is on, the contrast is controlled automatically, depending on the ambient light, measured by the ALC sensor {2} in the bezel.

Orbiter:

The Orbiter is an internal circuit that, when switched on, will slightly and slowly move the image to prevent pixel burn-in.

Power save:

This setting can switch the automatic power saving system (see Introduction chapter) on or off.

Display address:

In multi-head systems (multiple displays controlled by one system), each display must have a different address. With this setting you can set the display address from 1 to 16.

User controls disable:

With this setting you can enable or disable the user controls.

When OFF, the user controls are not disabled, and the user can activate and use the OSD menus.

When ON, the user controls are disabled. After quitting the OSD, the user will no longer be able to activate the OSD.

To activate the OSD again when the user controls are disabled, use the following "code":

1Turn the control knob 3 times counter-clockwise (seen from the rear).

2 Turn the control knob 3 times clockwise.

3Turn the control knob 3 times counter-clockwise. Note: This should be done in quite a short time!

Saving the settings

The settings are automatically saved after changing them.

Advanced 24