Stewart Filmscreen Corp 4-Way ScreenWall ElectriMask Infrared Sensor Infrared Remote Control

Page 15

Installing the infrared remote control option

The optional Stewart Filmscreen infrared remote control allows control of the screens from anywhere in the room.

Note: The distance between the hand-held remote control and the receiver can be up to 50 feet / 15.2m. It is necessary to have uninterrupted line-of- sight between the remote and the receiver.

Preparing the connection

Refer to the previous section on “Installing the low voltage 3-button switch option.”

Making the connection

Figure 11 illustrates the connections.

1.Mount the low-voltage control box near the mask.

2.Mount the infrared (IR) eye sensor near the mask.

3.Connect the low-voltage control box to the mask by connecting the mask motor power leads to the power strip terminal block located on the circuit board of the control box.

4.Connect the IR eye sensor to the small black plug-in module located next to the switch input on the circuit board.

5.Connect the low voltage control box to the AC power source by connecting the AC line voltage to the power strip terminal block located on the circuit board of the control box.

6.Connect the switch to the low-voltage control box.

Infrared Sensor

Infrared Remote Control

AC Power

Line

Neutral

COMMON-White

UP-Red

DOWN-Black

GROUND-Green

R/F Input

InfraRed Input

Low Voltage Switching

STOP-Yellow

COMMON-White

UP-Red

DOWN-Black

Low Voltage Control Box

4 Conductor Hook-up

 

20-24ga Recommended

Figure 11: Infrared remote control wiring

Category 5 Typically Used

(NOT Supplied)

3-Button

Momentary Switch

4-Way ScreenWall ElectriMask: Owner’s Manual

13

Image 15
Contents Way ScreenWall ElectriMask Page Way ScreenWall ElectriMask ContentsHorizontal Masking System To the OwnerAbout your 4-Way ScreenWall ElectriMask Vertical Masking SystemSize Table Attainable Aspect Ratios Row Diag Size 33/1Preparing the Installation PreparationUnpacking Assembling the frame Mounting the FrameWall Bracket Positioning the frame on the wallUnrolling the screen Unpacking and unrolling the screenSnapping screen onto frame Stewart Filmscreen Corporation Attaching the screen to frameSpring Tension Cable Baby Eye Snap Eyelet Connecting the spring tension cableHorizontal Mask Connection Vertical Mask Connection Electrical HOOK-UPMaking the connections Installing the high voltage switch control standardScreen Switch Preparing the connectionLow Voltage Control Box Installing the low-voltage 3-button switch optionButton Momentary Switch Making the connectionInfrared Sensor Infrared Remote Control Installing the infrared remote control optionInstalling the Multi-Channel Infrared Remote control option Mcir Control Board InfraredSensor Conductor Cable 14ga Recommended Pin conductors Connecting the Video Interface Control System VicsRomex Connector Terminal Block To 12V Trigger Wire to ProjectorHanging the screen Stewart Filmscreen Corporation Hanging the Frame on the WallOperating the Mask Adjusting the Mask ExtensionHorizontal Mask Vertical Mask Screen Modifying the extension of the maskVelux covering Screen Care and CleaningGeneral maintenance Replacement parts and serviceProblem description Probable cause Action to take TroubleshootingCan damage motor and screen Product WarrantyAdjustment. Failure to correc t Problem is resolved