PREPARING THE INSTALLATION
Before proceeding with the installation of this screen, take time to thoroughly read and understand these installation and operation instructions.
All electrical wiring installations must conform to local and national codes and should be performed by qualified service personnel.
There are no
Preparation
Specifications regarding the individual screen dimensions, weight, mounting type, and controls are provided by the factory when the unit is ordered. Before beginning the installation:
Check the specifications for the type of mounting and switch control to be used.
Prepare the wall for electrical access to the motor(s) (audience left).
Make sure there is a clean surface on which to unroll the screen.
Check the size and weight of the screen to be installed so that you can plan for the number of people required for the mounting procedure. You need at least two people to mount the smaller screens; more are needed for larger, heavier screens.
You will need:
Enough ladders for the personnel supporting the screen during the mounting process
A level
Fasteners appropriate for the surface on which the screen is being mounted (See instructions for the type of mount for recommendations.)
Phillips screwdriver
5/8” (1.6 cm) hex head screwdriver or Allen wrench
Caution
During installation, do not place the unit on an unstable cart, stand, table, or ladder. The unit may fall, causing injury to a child or adult and damage to the unit.
Unpacking
Remove the outer plastic covering and white wrapping paper surrounding the frame unit, if any. Do not remove the screen from the cardboard shipping tube until instructed to do so.
4 | Stewart Filmscreen Corporation |