Chapter 2 System Setup
21
2.2 Preparing For First-time Usage
Before you start to set up the panel PC system, you should have at
least the following items ready:
• Power inlet cable (in the accessory box)
• Male contact pin x 3 and female contact pin x 3 (in the accessory
box)
• A pair of DC power insulator with hood (in the accessory box)
• 34-pin external FDD flat cable for FDD (in the accessory box)
• 40-pin external IDE cable for HDD or CD-ROM (in the accessory box)
• 4-pin power cable for external FDD or IDE device (in the accessory
box)
• AT keyboard
• PS/2 or serial mouse (for system software installation i.e. Microsoft
Windows, NT, etc.....).
2.3 Installation Procedures

2.3.1 Connecting the power inlet cable (180 cm)

The panel PC can only be powered by DC 24 volts (DC 12 volts
optional) sources. Follow there procedures in order:
1.Connect the power inlet cable to power inlet connector of the panel PC.
2.Fasten the inlet tightly.

Note: The red wire of power inlet cable for positive power

source, the green wire is for frame ground and the

black is for negative power source.