Advantech PPC-A84/A120-X5X Installing a primary 2.5 HDD plug-in, Installing Dram Sodimm

2.3.3 Installing a primary 2.5" HDD (plug-in)

You can attach one enhanced Integrated Device Electronics (IDE) hard disk drive to the PPC-A84/A120's internal controller which uses a PCI local-bus interface. The advanced IDE controller supports faster data transfer rates and allows the IDE hard drive to exceed 528MB. The following are instructions for installation:

1.Find the black HDD carrier, the 44-pin transfer connector and four pieces of M3x4 screws, and two long screws for the 44-pin transfer connector in the accessory box.

2.Connect the transfer connector to 2.5" HDD, screw the two screws to fix the transfer with the HDD.

3.Put the HDD inside the black carrier. Screw the 4 screws to fix the HDD to carrier from two sides of the carrier.

4.Unscrew the two screws of the cover on the top side of PPC-A84/ A120 (See Fig.2-5). Open the cover.

5.Plug in the HDD carrier.

6.Close the cover and screw the two screws.

Note:	Make sure the power source to the PPC-A84/A120
	has been disconnected, before you plug in or remove
	the HDD drive.

2.3.4 Installing DRAM (SODIMM)

Chapter 2 System Setup 2 5