Cisco Systems 7200 VXR Installing the Brackets on the Front of the Chassis, Cisco Series VXR

Chapter 3 Installing a Cisco 7200 VXR Router

Rack-Mounting a Cisco 7200 VXR Router

Installing the Brackets on the Front of the Chassis

To install the rack-mount and cable-management brackets on a Cisco 7200 VXR router for a front rack-mount configuration, complete the following steps:

Step 1 Locate the threaded holes in the front sides of the chassis.

Step 2 If you want the front of the chassis protruding from the rack, align the first rack-mount bracket and the first cable-management bracket to the threaded holes in the right side of the chassis as shown in Figure 3-6.

Step 3 Thread two M4 x 8-mm Phillips flathead screws through both brackets and into the side of the chassis. Use a number 2 Phillips screwdriver to tighten the screws. (See Figure 3-6.)

Figure 3-6 Installing the Rack-Mount Brackets on the Front of the Chassis so the Front Protrudes from the Rack

5

3

1

Cisco 7200

Series VXR

ETHERNET 10BT

FAST SERIAL

ENABLED

					TOKEN RING
						6
					FAST ETHERNET
M II	L I N	K	R J	4	5	4
0
					ETHERNET-10BFL
						2
	FAST ETHERNET INPUT/OUTPUT CONTROLLER
						0

84521

1

12

Rack-mount bracket 2 Cable-management bracket

Step 4 If you want the front of the chassis recessed in the rack, align the first rack-mount bracket to the threaded holes in the right side of the chassis as shown in Figure 3-7.

Thread two M4 x 8-mm Phillips flathead screws through the bracket into the side of the chassis and use a number 2 Phillips screwdriver to tighten the screws. Then align the first cable-management bracket to the rack-mount bracket and thread two M4 x 8-mm Phillips flathead screws through the two brackets. Use a number 2 Phillips screwdriver to tighten the screws. (See Figure 3-7.)

Cisco 7200 VXR Installation and Configuration Guide

3-8 OL-5013-09