Cisco Systems 7200 VXR manual 32 to 104F 0 to 40C operating -4 to 149F -20 to 65C nonoperating

Chapter 1 Cisco 7200 VXR Product Overview

Physical Description

	See Table 1-1for the Cisco 7200 VXR physical specifications and power requirements:
Table 1-1	Physical Specifications
Description	Specification
Midplane	Two primary PCI buses, and one secondary PCI bus

•With an NPE-G2 or NPE-G1 and an I/O controller installed, the I/O controller does not use bandwidth points, and the NPE-G2 or NPE-G1 does use bandwidth points. The NPE-G2 or NPE-G1 does not use bandwidth points if installed without the I/O controller.

•With an NSE-1, NPE-400, or NPE-300 installed: aggregate bandwidth of 900 Mbps1

•With n NPE-100, NPE-150, or NPE-200 installed: aggregate bandwidth of 600 Mbps

	Three primary PCI buses—With the NPE-G2 or NPE-G1 installed, no I/O controller, and the Port
	Adapter Jacket Card installed, three PCI buses are available. Aggregate bandwidth of the PCI buses
	is 900 Mbps. The third PCI bus goes to the Port Adapter Jacket Card and provides unlimited
	bandwidth for one port adapter.
Dimensions	5.25 in. x 16.8 in. x 17 in. (13.34 cm x 42.67 cm x 43.18 cm)
(H x W x D)
Weight	Chassis fully configured with a network processing engine or network services engine, I/O
	controller, maximum number of port adapters, 2 power supplies, and a fan tray: ~ 50 lb (22.7 kg)
Heat dissipation	370W (1262 BTU2)
Chassis fan noise	Tested:
levels—single speed	• Front (I/O controller and port adapter side) 44.2 dB
fan
	• Back (power supply side) 43.7 dB
	• Left (fan side) 47.2 dB
	• Right 44.8 dB
	Maximum: 65 dB
Airflow	~80 cfm3
Temperature	32 to 104•F (0 to 40•C) operating; –4 to 149•F (–20 to 65•C) nonoperating
Humidity	10 to 90% noncondensing
Power Specifications
AC-input voltage rating	100–240 VAC4 wide input with power factor correction
AC-input current rating	5A5 at 100–240 VAC with the chassis fully configured
AC-input frequency	50/60 Hz6
rating
AC-input cable	18 AWG7 three-wire cable, with a three-lead IEC-320 receptacle on the power supply end, and a
	country-dependent plug on the power source end
DC-output power	280W maximum (with either a single or dual power supply configuration)
DC-input voltage rating	–48 VDC8 nominal in North America
	–60 VDC nominal in the European Community

Cisco 7200 VXR Installation and Configuration Guide

OL-5013-09 1-3