Cisco Systems 7200 VXR manual Viewing Your System Configuration, 4-20

Chapter 4 Observing System Startup and Performing a Basic Configuration

Viewing Your System Configuration

Viewing Your System Configuration

You can use the show version and the show diag commands to view information specific to the hardware configuration of your Cisco 7200 VXR router.

Use the show version (or show hardware) command to display the system hardware (the network processing engine or network services engine and the number of interfaces installed), the software version, the names and sources of configuration files, and the boot images.

The following sample output of the show version command shows an NPE-G1 installed in the Cisco 7206VXR.

Router# show version

Cisco Internetwork Operating System Software

IOS (tm) 7200 Software (C7200-JS-M), Released Version 12.2(20011220:181136) [biff dec21 101]

Copyright (c) 1986-2002 by cisco Systems, Inc. Compiled Fri 21-Dec-01 05:58 by

Image text-base:0x600089B8, data-base:0x6196E000

(sample text omitted)

term1_500 uptime is 1 day, 19 hours, 25 minutes

System returned to ROM by reload at 00:04:18 UTC Tue Nov 30 1999 System image file is "disk2:c7200-js-mz.dev-test.dec21"

cisco 7206VXR (NPE-G1) processor (revision 0x00) with 245760K/16384K bytes of memory. Processor board ID 13250983

BCM12500 CPU at 700Mhz, Implementation 1, Rev 0.1, 512KB L2 Cache 6 slot VXR midplane, Version 2.0

Last reset from power-on

Bridging software.

X.25 software, Version 3.0.0.

SuperLAT software (copyright 1990 by Meridian Technology Corp).

TN3270 Emulation software.

5 FastEthernet/IEEE 802.3 interface(s)

3 Gigabit Ethernet/IEEE 802.3 interface(s)

509K bytes of non-volatile configuration memory.

62528K bytes of ATA PCMCIA card at slot 2 (Sector size 512 bytes). 16384K bytes of Flash internal SIMM (Sector size 256K). Configuration register is 0x0

Use the show diag command to determine what type of port adapters and I/O controller (with or without the Fast Ethernet port) are installed in slot 0 through slot 4 of your Cisco 7204VXR or slot 0 through slot 6 of your Cisco 7206VXR. You can also use the show diag slot command to display information about a specific port adapter slot.

The following example shows the show diag command output from a Cisco 7206VXR with an NPE-G1 installed.

Router# show diag

Slot 0:

Dual FastEthernet (RJ-45) I/O Card Port adapter, 2 ports

Port adapter is analyzed

Port adapter insertion time 1d19h ago

EEPROM contents at hardware discovery:

	Hardware Revision	:0.0
	Board Revision	:01
	Connector Type	:FF
	Cisco 7200 VXR Installation and Configuration Guide
4-20		OL-5013-09