Cisco Systems 7200 VXR manual Connecting Power, 3-41, continued

Chapter 3 Installing a Cisco 7200 VXR Router

Connecting Power

Table 3-19	Auxiliary Port Signals for NPE-G2, NPE-G1 and C7200-I/O-2FE/E and C7200-I/O-GE+E
	(continued)
Pin1	Signal	Direction	Description
5	GND	—	Signal Ground
6	RXD	In	Receive Data
73	DSR/DCD	In	Data Set Ready/Data Carrier Detect
	(RLSD)		(Receive Line Signal Detect)
8	CTS	In	Clear To Send

1.Any pin not referenced is not connected.

2.RING is not supported on Cisco-supplied adapters. To use this pin, you must create a customized cable.

3.Pin 7 can be used as a DCD input for connection to a modem. The RJ-45-to-DB-25F adapter maps DCD to this pin when the adapter is used with a straight-through cable. (See Table 3-16.)

Note When connecting to an auxiliary port on a Cisco 7200 VXR router, the port will not function at baud rates higher than 19.2k. If the baud rate on the connecting device is set higher than 19.2k, either garbled text or nothing will be displayed on the screen

Connecting Power

This section provides the procedures for connecting AC-input and DC-input power to your Cisco 7200 VXR router.

Warning This unit might have more than one power cord. To reduce the risk of electric shock, disconnect the two power supply cords before servicing the unit. Statement 14

Note Detailed instructions for handling and replacing the Cisco 7200 VXR power supplies are contained in the 280-Watt AC Power Supply Replacement Instructions and 280-WattDC-Input Power Supply Replacement Instructions documents. These documents are available on the Documentation DVD and on Cisco.com.

Warning The AC power supply has double pole/neutral fusing. Statement 188

Cisco 7200 VXR Installation and Configuration Guide

OL-5013-09 3-41