Stewart Filmscreen Corp 4-Way ScreenWall ElectriMask Positioning the frame on the wall

Page 8

Positioning the frame on the wall

1.Without the screen fabric attached, position the frame on the wall.

2.Make sure the unit is level and plumb. (You may need to use shims between the brackets and the wall to achieve vertical plumb).

3.Mark the position of the bracket holes on the wall. See Figure 4.

Note: Later, when the screen fabric is attached to the frame (next section), you will hang the frame on the wall.

Caution

If the unit is not mounted so that it is level and plumb, horizontal masking panels may jam on retraction.

Wall Bracket

Figure 4: Positioning the frame

6	Stewart Filmscreen Corporation

Image 8

Contents Way ScreenWall ElectriMask Page Contents Way ScreenWall ElectriMaskTo the Owner About your 4-Way ScreenWall ElectriMaskVertical Masking System Horizontal Masking SystemRow Diag Size 33/1 Size Table Attainable Aspect RatiosUnpacking Preparing the InstallationPreparation Mounting the Frame Assembling the framePositioning the frame on the wall Wall BracketUnpacking and unrolling the screen Unrolling the screenAttaching the screen to frame Snapping screen onto frame Stewart Filmscreen CorporationConnecting the spring tension cable Spring Tension Cable Baby Eye Snap EyeletElectrical HOOK-UP Horizontal Mask Connection Vertical Mask ConnectionInstalling the high voltage switch control standard Screen SwitchPreparing the connection Making the connectionsInstalling the low-voltage 3-button switch option Button Momentary SwitchMaking the connection Low Voltage Control BoxInstalling the infrared remote control option Infrared Sensor Infrared Remote ControlSensor Installing the Multi-Channel Infrared Remote control optionMcir Control Board Infrared Connecting the Video Interface Control System Vics Romex ConnectorTerminal Block To 12V Trigger Wire to Projector Conductor Cable 14ga Recommended Pin conductorsHanging the Frame on the Wall Hanging the screen Stewart Filmscreen CorporationAdjusting the Mask Extension Operating the MaskModifying the extension of the mask Horizontal Mask Vertical Mask ScreenScreen Care and Cleaning General maintenanceReplacement parts and service Velux coveringTroubleshooting Problem description Probable cause Action to takeProduct Warranty Adjustment. Failure to correc tProblem is resolved Can damage motor and screen