Teledyne 3190 manual Drawing List, Miscellaneous

Page 41

Trace Oxygen Analyzer		Appendix

A.3 Drawing List

C-64772 Outline diagram

C-64641 Final Assembly (and interconnection diagram)

D-65666 Control Unit Assembly

B-65992 Analysis unit outline

A.4 Miscellaneous

The symbol: ~ is used on the rear panel of the model 3190 to signify volts alternating current (V ac).

NOTE: The MSDS on this material is available upon request through the Teledyne Environmental, Health and Safety Coordinator. Contact at (626) 934-1592

Teledyne Analytical Instruments

A-3

Image 41

Contents Teledyne Analytical Instruments Model 3190 SeriesCopyright 1999 Teledyne Analytical Instruments Specific Model Information Contents Appendix MaintenanceTeledyne Analytical Instruments Introduction Main Features of the AnalyzerOverview Trace Oxygen Analyzer IntroductionIntroduction Model Front Panel DescriptionUp Arrow Rear Panel DescriptionRear Panel AC and DC versions Analog OutputsRS-232 Port Introduction Model Teledyne Analytical Instruments Introduction Operational TheoryMicro-Fuel Cell Sensor Trace Oxygen Analyzer Operational TheoryAnatomy of a Micro-Fuel Cell Operational Theory Model+ 2H 2O + 4e → 4OH Electrochemical ReactionsEffect of Pressure Calibration CharacteristicsGeneral Signal ProcessingElectronics Block Diagram of the Signal Processing Electronics Unpacking the Analyzer InstallationTrace Oxygen Analyzer Installation Control Unit Installation Installation ModelExternal Probe Installation Location and MountingElectrical Connections Installing the Micro-Fuel Cell / Cell Block OrientationRear Panel Electrical Connectors for AC and DC Units Trace Oxygen Analyzer Installation LO Alarm HI AlarmParameter Setting Sensor FailGas Connections Installation ChecklistInstallation Model Teledyne Analytical Instruments Trace Oxygen Analyzer Operation Using the Function and Data EntryOperation Operation Model Setting the Analysis RangesButtons Settle Mode Setting the Alarm SetpointsHI Alarm Trace Oxygen Analyzer Operation HI RangeSensor Fail Alarm LO AlarmSelecting a Fixed Range or Autoranging CalibrationDisplaying Percent & PPM on the LED Display ProcedureSetL mode in the LED display Trace Oxygen Analyzer Maintenance MaintenanceAC Powered Units Replacing the FuseMaintenance Model Sensor Installation or ReplacementDC Powered Units When to Replace a SensorRemoving the Micro-Fuel Cell Disconnect the Power Source at the Control UnitExploded View of MFC and Cell Block Installing a Micro-Fuel CellCell Warranty Conditions Disconnect the Power Source from the Control UnitMaintenance Model Teledyne Analytical Instruments Trace Oxygen Analyzer Appendix Appendix SpecificationsAppendix Model Spare Parts ListMiscellaneous Drawing ListAppendix Model Teledyne Analytical Instruments