M102E/M501 TRS, Teledyne, Instruments, Rev A

M102E/M501 TRS

Addendum to Appendix C M101E Manual (P/N 04740)

Warranty/Repair

Questionnaire

Model 102E

TELEDYNE

INSTRUMENTS

Advanced Pollution Instrumentation

A Teledyne Technologies Company

Company: _________________________ Contact Name: _____________________________

Phone Number: ___________ Fax Number: _____________ Email: ____________________

Site Address: __________________________________________________________________

Can we connect to the instrument? If so, provide IP address or modem #:___________________

Model 102E Serial Number: _____________________ Firmware revision: _________________

The serial number can be found on the back of the instrument, the firmware revision is displayed in the upper left corner of the display when pressing SETUP on the front panel (Example: C.3).

1.List all front panel error/warning messages:_________________________________________

______________________________________________________________________________

2.Please complete the following table: (Depending on options installed, not all test parameters shown below may be available in your instrument)

PARAMETER	RECORDED	ACCEPTABLE	PARAMETER	RECORDED	ACCEPTABLE
PARAMETER	VALUE	VALUE	PARAMETER	VALUE	VALUE
	VALUE	VALUE		VALUE	VALUE
RANGE	ppb/ppm	50 ppb - 20 ppm	SO2 SLOPE		1.0	± 0.3

S02 STB	ppb	≤ 1 ppb with zero	TRS SLOPE		1.0	± 0.3
		air
TRS STB	ppb	≤ 1 ppb with zero	SO2 OFFS	mV	< 250
		air
SAMP FL	cm³/min	500 ± 50	TRS OFFS	mV	< 250

PMT signal	mV	-20 to 150	HVPS	V	5500-900
with zero air	mV	-20 to 150	HVPS	V	5500-900
with zero air

PMT signal at	mV	0-5000	ETEST	mV	2000	± 1000
span gas conc	ppb/ppm	0-20 000 ppb	ETEST	mV	2000	± 1000
span gas conc	ppb/ppm	0-20 000 ppb

NORM PMT at	mV	0-5000	OTEST	mV	2000	± 1000
span gas conc	ppb/ppm	0-20 000 ppb	OTEST	mV
span gas conc	ppb/ppm	0-20 000 ppb

UV LAMP	mV	2 000 to 4 000	RCELL TEMP	°C	50 ± 1

STR. LGT	ppm	≤ 100 ppb/ zero	BOX TEMP	°C	Ambient + ~5
		air
DARK PMT	mV	-50 to 200	PMT TEMP	°C	7	± 2

DARK LAMP	mV	-50 to 200	IZS TEMP	°C	50 ± 3

3.Has the analyzer been checked for leaks? Yes No For proper flows? Yes No

4.What are the failure symptoms? _________________________________________________

______________________________________________________________________________

______________________________________________________ Continue on back if necessary

5.Which tests have you done trying to solve the problem? _______________________________

______________________________________________________________________________

________________________________________________________ Continue on back if necessary

6.If possible, fax a portion of a strip chart or email a data file to customer service.

CUSTOMER SERVICE CONTACT INFORMATION: 6565 Nancy Ridge Drive, San Diego, CA 92121.

PHONE: +1 858 657 9800 or 1-800 324 5190. FAX: +1 858 657 9816.

EMAIL: api-customerservice@teledyne.com.

You can access and submit an online version of this form at http://www.teledyne-api.com/forms/csforM102E.asp

05517 Rev A

C-1