Emerson LC420EM8 owner manual Do not handle the power cord with wet hands, Location and Handling

Page 3

This apparatus should not be placed in a built-in installation such as a bookcase or rack unless proper ventilation is provided. Make sure to leave a space of 3.2 inches (8cm) or more around this apparatus.

Disconnect the mains plug to shut off when find trouble or not in use. The mains plug shall remain readily operable.

CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.

WARNING: Batteries (battery pack or battery installed) shall not be exposed to excessive heat such as sunshine, fire or the like.

LAMP IN LCD CONTAINS MERCURY, DISPOSE ACCORDING TO LOCAL, STATE OR FEDERAL LAW.

WARNING: To prevent injury, this apparatus must be securely attached to the floor/wall in accordance with the instructions.

TO AVOID THE HAZARDS OF ELECTRICAL SHOCK AND FIRE

•Do not handle the power cord with wet hands.

•Do not remove this unit cabinet. Touching parts inside the cabinet could result in electric shock and/or damage to this unit. For service and adjustment inside the cabinet, call a qualified dealer or an authorized service center.

•Do not pull on the power cord when disconnecting it from an AC outlet. Grasp it by the plug.

•Do not put your fingers or objects into the unit.

LOCATION AND HANDLING

•The openings should not be blocked by placing the unit on a bed, sofa, carpet, rug, or other similar surface.

•Do not install the unit near or over a radiator or heat register.

•Do not install the unit in direct sunlight, near strong magnetic fields, or in a place subject to dust or strong vibration.

•Avoid a place with drastic temperature changes.

•Install the unit in a horizontal and stable position. Do not place anything directly on top or bottom of the unit. Depending on your external devices, noise or disturbance of the picture and/or sound may be generated if the unit is placed too close to them. In this case, please ensure enough space between the external devices and the unit.

•Depending on the environment, the temperature of this unit may increase slightly. This is not a malfunction.

NOTE ABOUT RECYCLING

• This unit’s packaging materials are recyclable and can be reused. Please dispose of any materials in accordance with your local recycling regulations.

•Batteries should never be thrown away or incinerated but disposed of in accordance with your local regulations concerning chemical wastes.

WHEN CARRYING THIS UNIT

•At least two people are required when carrying this unit.

•Make sure to hold the upper and bottom frames of the unit firmly as illustrated.

INTRODUCTION PREPARATION INITIAL SETTING WATCHING TV OPTIONAL SETTING TROUBLESHOOTING INFORMATION

3

EN

Page 2 Page 4
Image 3
Page 2 Page 4
Contents LC420EM8 To Receive DIGITAL/ANALOG SIGNAL, YOU Must Connect AntennaRADIO-TV Interference PrecautionsIntroduction FCC WarningLocation and Handling Do not handle the power cord with wet handsAvoid a place with drastic temperature changes When Carrying this Unit5Trademark Information 5Supplied Accessories5Symbols Used in this Manual 5Attaching the StandFeatures ContentsDTV/TV/CATV 5Installing the Batteries 5Buttons on the Remote Control5Rear Panel 5Control PanelConnection to Cable Box or Satellite Box Preparation5Basic Connection Antenna Connection5External Device Connection Hdmi ConnectionHDMI-DVI Connection Video Connection Component Video ConnectionAnalog Audio Output Connection# Caution 5Attaching a Wall Mount Bracket sold separatelyScanning and memorizing of channels start automatically Initial Setting5Initial Setup Make sure if the unit is connected to antenna or cable5Auto Channel Scan 5Main MenuPress Setup to exit 5Language SelectionLanguage 5Channel Selection 5Volume Adjustment5Sleep Timer Watching TV5Still Mode 5Switching Each Mode5Switching Audio Mode Day of Memoriesi 5Screen InformationBroadcasting Information Press Info5TV Screen Display Mode Enter Optional Setting5Channel List 5Manual RegisterAntenna 5Antenna Confirmation5Picture Adjustment Surround 5Sound AdjustmentYou can adjust treble, bass and surround Adjust the sound settingCC2, CC4, Text2 and Text4 Caption Mode CC1 and Text15Closed Caption CC3 and Text35DTV Closed Caption DTV CCUse Cursor K/L to select DTV CC, then press Enter Font Size Setting description for each item is shown below5CC Style Font StyleBack Opacity Font ColorFont Opacity Back ColorChip ip Chipip Enter passwordChip Use Cursor K/L to select V-chip, then press EnterChipip To Set the Sub RatingsUse Cursor K/L to select Mpaa Rating, then press Enter Use Cursor K/L to select TV Rating, then press EnterChipip Enter password Confirm password Use Cursor K/L to select New Password, then press EnterHDMI1 5HDMI AudioTroubleshooting 5Troubleshooting GuideSymptom Remedy Delayed behind the dialogue Check the batteries of the remote controlRefer to IR Signal Check on Interrupt the remote control signal of this unitWith an AM radio MaintenanceInformation Glossary5Cable Channel Designations 5General Specifications5Electrical Specification 5Other SpecificationsLimited Warranty Manual del Usuario Advertencia DE LA FCC IntroducciónPrecauciones Número de serieTransporte DE Esta Unidad Para Evitar Peligros DE Descarga Eléctrica O IncendioColocación Y Manejo Nota Acerca DEL Reciclado5Información sobre Marcas Registradas 5Accesorios Suministrados5Conectar el Soporte 5Símbolos Utilizados en este ManualContenido Características5Instalación de las Pilas 5Botnes en el Mando a Distancia5Panel Trasero 5Panel de ControlConexión a Caja de Cable o Caja de Satélite Preparación5Conexión Básica Conexión de Antena5Conexión de Dispositivo Externo Conexión HdmiConexión HDMI-DVI Conexión de S-video Conexión de Vídeo en ComponentesConexión de Vídeo Conexión de Salida de AudioAnalógica # Cuidado 5Configuración Inicial Ajuste InicialEsta operación tardará unos momentos 5Exploración Automática de Canales 5Menú PrincipalPresione Setup para salir 5Selección de IdiomaIdiomaI 5Temporizador de Apagado 5Ajuste de VolumenPara VER LA Televisión 5Selección de Canal5Modo Fijo 5Para Cambiar entre Cada ModoEstéreo Un díaía de recuerdos 5Información de PantallaInformación de emisión Presione Info5Modo de Visualización de Pantalla del Televisor Lista Canales l Ajuste Opcional5Lista de Canales 5Registro ManualAntena 5Confirmación de la AntenaModo de Imagen 5Ajuste de ImagenRestablecer Ajustes Tempe. de ColorUtilice Cursor K /L para seleccionar Restablecer, y 5Ajuste de SonidoAgudo, Grave Función surround, luego presione Enter2, S.C.4, Texto2 y Texto4 SubtítulosModo de subtítulos S.C.1 y Texto1 3 y Texto3DTV deseados, y luego presione Enter 5Subtítulos en DTVComo sigue 5Estilo CCTamaño Fuente Luego presione EnterOpaco Atrás Color FuenteTipo Borde Color FondoChipip Introduzca cód. de acceso Clasificación deseada y luego presione Enter Para Ajustar las SubcategoríasPicture Association of America Utilice Cursor K/L/s/B para seleccionar laNueva Código de Acceso Audio 5Audio HdmiSolución DE Problemas 5Guía de Solución de ProblemasSíntoma Solución Infrarrojos en la parte delantera de la unidad El número de canalIntroducido cambia Con el sensor de infrarrojosCon una radio AM InformaciónGlosario Mantenimiento5Otras Especificaciones 5Denominaciones de Canales de Cable5Especificaciones Generales 5Especificación EléctricaGarantía Limitada
Top Page Image Contents