Emerson LC420EM8 5Supplied Accessories, 5Attaching the Stand, 5Symbols Used in this Manual

Page 4

INTRODUCTION

5Supplied Accessories

owner’s manual					quick start guide	remote control				batteries	Phillips pan screw for
(1EMN22446)					(1EMN22447)	(NF020UD)				(AA x 2)	attaching the stand x 4
											(FPH34100)

•If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free customer support line found on the cover of this manual.

•Depending on your antenna system, you may need different types of combiners (mixers) or separators (splitters). Contact your local electronics store for these items.

5Attaching the Stand

You must attach the stand to the unit to display upright. Be sure the front and rear of the stand match the proper direction.

1 Spread a thick and soft cloth over	2 Insert the stand all the way to the	3 Drive Phillips pan screws in the
a table.	main unit slowly.	4 threaded holes at the bottom
Place the main unit face down	Make sure not to put the AC cord	of the stand with a screwdriver
onto it.	between the stand and the unit.	tightly.
Make sure not to damage the
screen. At least two people are
required at this step.

screw holes

front side

Note:

•When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall, resulting in injuries as well as damage to the unit.

•Make sure to use a table which can support the weight of this unit and is larger than this unit.

•Make sure the table is in a stable location.

•If you removed the stand shafts from this unit for wall mounting, make sure that you attach them before attaching the stand.

5Symbols Used in this Manual

The following is the description for the symbols used in this manual.

Description refers to:

DTV

: Digital TV operation

TV

: Analog TV operation

• If neither symbol appears under the function heading, operation is applicable to both.

5Trademark Information

•HDMI, the HDMI logo and High-Definition Multimedia Interface are trademarks or registered trademarks of HDMI Licensing LLC.

•Manufactured under license from Dolby Laboratories. “Dolby” and the double-D symbol are trademarks of Dolby Laboratories.

•Product that have earned ENERGY STAR® are designed to protect the environment through superior energy efficiency.

4

EN

Image 4

Contents To Receive DIGITAL/ANALOG SIGNAL, YOU Must Connect Antenna LC420EM8Precautions IntroductionFCC Warning RADIO-TV InterferenceDo not handle the power cord with wet hands Avoid a place with drastic temperature changesWhen Carrying this Unit Location and Handling5Supplied Accessories 5Symbols Used in this Manual5Attaching the Stand 5Trademark InformationContents FeaturesDTV/TV/CATV 5Buttons on the Remote Control 5Installing the Batteries5Control Panel 5Rear PanelPreparation 5Basic ConnectionAntenna Connection Connection to Cable Box or Satellite BoxHdmi Connection 5External Device ConnectionHDMI-DVI Connection Component Video Connection Video ConnectionAudio Output Connection Analog5Attaching a Wall Mount Bracket sold separately # CautionInitial Setting 5Initial SetupMake sure if the unit is connected to antenna or cable Scanning and memorizing of channels start automatically5Main Menu 5Auto Channel Scan5Language Selection Press Setup to exitLanguage 5Volume Adjustment 5Sleep TimerWatching TV 5Channel Selection5Switching Each Mode 5Still Mode5Switching Audio Mode 5Screen Information Broadcasting InformationPress Info Day of Memoriesi5TV Screen Display Mode Optional Setting 5Channel List5Manual Register Enter5Antenna Confirmation Antenna5Picture Adjustment 5Sound Adjustment You can adjust treble, bass and surroundAdjust the sound setting SurroundCaption Mode CC1 and Text1 5Closed CaptionCC3 and Text3 CC2, CC4, Text2 and Text4DTV CC 5DTV Closed CaptionUse Cursor K/L to select DTV CC, then press Enter Setting description for each item is shown below 5CC StyleFont Style Font SizeFont Color Font OpacityBack Color Back OpacityChipip Enter password ChipUse Cursor K/L to select V-chip, then press Enter Chip ipTo Set the Sub Ratings Use Cursor K/L to select Mpaa Rating, then press EnterUse Cursor K/L to select TV Rating, then press Enter ChipipUse Cursor K/L to select New Password, then press Enter Chipip Enter password Confirm password5HDMI Audio HDMI15Troubleshooting Guide TroubleshootingSymptom Remedy Check the batteries of the remote control Refer to IR Signal Check onInterrupt the remote control signal of this unit Delayed behind the dialogueMaintenance InformationGlossary With an AM radio5General Specifications 5Electrical Specification5Other Specifications 5Cable Channel DesignationsLimited Warranty Manual del Usuario Introducción PrecaucionesNúmero de serie Advertencia DE LA FCCPara Evitar Peligros DE Descarga Eléctrica O Incendio Colocación Y ManejoNota Acerca DEL Reciclado Transporte DE Esta Unidad5Accesorios Suministrados 5Conectar el Soporte5Símbolos Utilizados en este Manual 5Información sobre Marcas RegistradasCaracterísticas Contenido5Botnes en el Mando a Distancia 5Instalación de las Pilas5Panel de Control 5Panel TraseroPreparación 5Conexión BásicaConexión de Antena Conexión a Caja de Cable o Caja de SatéliteConexión Hdmi 5Conexión de Dispositivo ExternoConexión HDMI-DVI Conexión de Vídeo en Componentes Conexión de S-videoConexión de Salida de Audio Conexión de VídeoAnalógica # Cuidado Ajuste Inicial 5Configuración InicialEsta operación tardará unos momentos 5Menú Principal 5Exploración Automática de Canales5Selección de Idioma Presione Setup para salirIdiomaI 5Ajuste de Volumen Para VER LA Televisión5Selección de Canal 5Temporizador de Apagado5Para Cambiar entre Cada Modo 5Modo FijoEstéreo 5Información de Pantalla Información de emisiónPresione Info Un díaía de recuerdos5Modo de Visualización de Pantalla del Televisor Ajuste Opcional 5Lista de Canales5Registro Manual Lista Canales l5Confirmación de la Antena Antena5Ajuste de Imagen Restablecer AjustesTempe. de Color Modo de Imagen5Ajuste de Sonido Agudo, GraveFunción surround, luego presione Enter Utilice Cursor K /L para seleccionar Restablecer, ySubtítulos Modo de subtítulos S.C.1 y Texto13 y Texto3 2, S.C.4, Texto2 y Texto45Subtítulos en DTV DTV deseados, y luego presione Enter5Estilo CC Tamaño FuenteLuego presione Enter Como sigueColor Fuente Tipo BordeColor Fondo Opaco AtrásChipip Introduzca cód. de acceso Para Ajustar las Subcategorías Picture Association of AmericaUtilice Cursor K/L/s/B para seleccionar la Clasificación deseada y luego presione EnterNueva Código de Acceso 5Audio Hdmi Audio5Guía de Solución de Problemas Solución DE ProblemasSíntoma Solución El número de canal Introducido cambiaCon el sensor de infrarrojos Infrarrojos en la parte delantera de la unidadInformación GlosarioMantenimiento Con una radio AM5Denominaciones de Canales de Cable 5Especificaciones Generales5Especificación Eléctrica 5Otras EspecificacionesGarantía Limitada