Magnifying and searching for details
If you need to find the details on the projected picture, magnify the picture. Use the direction arrow keys for navigating the picture.
•Using the remote control
1.Press Magnify +/- to display the Zoom bar.
2.Press Magnify + to magnify the center of the
picture. Press the key repeatedly until the picture size is suitable for your need.
3. Use the directional arrows ( 
, 
, 
, 
) on the projector or remote control to navigate the picture.
4.To restore the picture to its original size, press AUTO. You can also press Magnify
•Using the OSD menu
1.Press MENU/EXIT on the projector or MENU on the remote control and then press
/ 
until the DISPLAY menu is highlighted.
2.Press 
to highlight Zoom and press MODE/ENTER on the projector or Enter on the remote control. The Zoom bar is displayed.
3.Repeat steps
4.Press 
on the projector repeatedly to magnify the picture to a desired size.
5.To navigate the picture, press MODE/ENTER on the projector or Enter on the remote control to switch to the paning mode and press the directional arrows ( 
, 
, 
, 
) to navigate the picture.
6.Use the directional arrows (
, 
, 
, 
) on the projector or remote control to navigate the picture.
7.To reduce size of the picture, press MODE/ENTER on the projector or Enter on the remote control to switch back to the zoom in/out functionality, and press AUTO to
restore the picture to its original size. You can also press 
repeatedly until it is restored to the original size.
The picture can only be navigated after the picture is magnified. You can further magnify the picture while searching for details.
Selecting the aspect ratio
The 'aspect ratio' is the ratio of the image width to the image height. Most analog TV and computers are in 4:3 ratio, which is the default for this projector, and digital TV and DVDs are usually in 16:9 ratio.
With the advent of digital signal processing, digital display devices like this projector can dynamically stretch and scale the image output to a different aspect than that of the image input signal.
To change the projected image ratio (no matter what aspect the source is):
1.Press MENU/EXIT on the projector or MENU on the remote control and then press
/ 
until the DISPLAY menu is highlighted.