PYLE Audio DVDR5520H user manual Connecting to a VCR or other similar device, VCR example only

English

Step 2: Optional Connections (continued)

VCR (example only)

				DIGITAL
				ANTENNA INPUT
		ANTENNA INTERCONNECT CABLE	DIGITAL ANTENNA
		(OPTIONAL, REFER TO MANUAL)	LOOP THROUGH	CVBS-OUT
G-LINK	TO TV	EXT1	TO VCR/SAT	EXT2
TO TV ANTENNA	ANALOG			S-VIDEO
INPUT	ANTENNA INPUT			OUT

VHF/UHF
RF IN		SCART OUT		SCART IN
VHF/UHF
RF OUT
				D
HDMI
OUT				MAINS
	Y	PB
L
		PR
R
AUDIO	COAXIAL	COMPONENT	COAXIAL
			DIGITAL
OUT	DIGITAL OUT VIDEO OUT		IN

B

TV

C

Connecting to a VCR or other similar device

This connection enables you to record from video tape to hard disk and allows the VCR to be used for playback on the TV if the recorder is turned off.

Note:

Your new recorder can replace the VCR for all your recording needs. Just unplug all the connections to your VCR.

A Connect the antenna cables. See ‘Connecting the antenna cables’ in Step 1: Basic Connections chapter for more information.

B Connect a RF antenna cable (supplied) from the TO TV ANTENNA INPUT socket on the recorder to the antenna input socket on your TV (usually labelled as ANT, ANTENNA IN, RF IN).

C Connect a scart cable (supplied) from the EXT1-TO TV socket on the recorder to the corresponding SCART socket on the TV.

D Connect another scart cable (not supplied) from the EXT2-TO VCR/ SAT socket on the recorder to the Scart socket (usually labelled as TV OUT or TO TV) on the VCR.

Helpful Hints:

–Most commercial video cassettes and DVDs are copy-protected and therefore cannot be recorded.

–Connect the recorder directly to the TV. If there is a VCR or an additional device in between, the picture quality may be poor.

22