English
Troubleshooting
WARNING!
Under no circumstances should you try to repair the system yourself, as this will invalidate the warranty. Do not open the system as there is a risk of electric shock.
If a fault occurs, first check the points listed below before taking the system for repair. If you are unable to solve a problem by following these hints, consult your dealer or Philips for help.
Problem (General) |
| Solution |
No power. | – | Press the |
|
| to turn on the power. |
| – | Make sure the mains cord is properly connected and the |
|
| AC outlet has power. |
The message ‘IS TV ON?’ appears on the display panel.
The buttons on the recorder do not work.
Remote control does not work.
–This recorder will not operate until you complete the first installation. See ‘Step 3: Installation and
–There is a technical problem. Disconnect the recorder from the power outlet for 30 seconds, then connect again. If the recorder still will not operate, then reset it to the default factory settings :
1)Disconnect the recorder from the power outlet.
2)Press and hold down
3)Release
4)Wait until the recorder’s demo start scrolling on the display, press
–Aim the remote control directly at the sensor on the front of this recorder (not towards TV).
–Remove any obstacles between recorder and the remote control.
–Batteries are weak, replace the batteries.
98