English
System Menu Options (continued)
Analogue Tuner settings
Auto search
Follow TV
Manual install
Press OK on the remote control to start the automatic TV channel search process and replace all previously stored analogue TV channels. This process may take several minutes.
This feature is only available if you have connected this recorder to your TV using the
1)Press OK the remote control to access.
2)Press OK to confirm the message on the TV, ‘TV 01’ appears on the display panel. Use the TV’s remote control to select programme number {1} at your TV, then press OK on the recorder’s remote control.
–If the recorder finds the same TV channel as on the TV, it stores it as ‘P01’. ‘TV 02’ will then appear on the display panel.
–If no video signal is received from the TV, ‘NO TV’ will appear.
–If you make a mistake, press BACK button to return to ‘TV 01’ setting.
3)Use the TV’s remote control to select programme number {2} at your TV, then press OK on the recorder’s remote control. Repeat the above steps until you have assigned all the TV channels.
4)To exit the menu, press OPTIONS.
Note: The Follow TV feature may not work properly on every TV. In case no channels are matched, please proceed with manual install.
Use this setting only if the automatic install detected the wrong tuner signals.
{Entry mode } – Select manual search based on channel allocation or frequency entry
{ CH (channel),
{Entry } – Use the alphanumeric keypad
OR
–Press the Blue button on the remote control for { Search }, once you have found the correct frequency/channel, press the Green button for { Store }.
86