Sanyo TLS-224P Output Terminals, Remote Jack, SW OUT Terminal Output Setting

OUTPUT TERMINALS

SW OUT Terminal

When recording, a pulse signal is output at the SW OUT terminal.

This terminal is usually connected to the switch input (SW IN) of devices like a camera switcher unit, or a quad compressor.

5V (H)

(Output impedance: 5.7 kΩ) 0V (L)

SW OUT Terminal Output Setting

1Press the AUDIO ON/MENU button until the (SET UP 4) menu is displayed.

°The FIELD (or FRAME) setting is flashing.

<SET UP 4>

öSW OUT
FIELD	01
TIMING	FIELD
3H	Y

<USED TIME>

VIDEO 00000H

POWER 00000H

NOTE:

•If “TIMING” is set to FRAME (see step 4), “FRAME” will be indicated instead of “FIELD”.

2Press the l (or j) button, to set the pulse signal interval.

Available settings are:

FIELD . . . . . . . . . . 01, 02, 03, 04, 05, 10, 30 or

60 field

FRAME . . . . . . . . . 01, 02, 03, 04, 05, 10, 30 or 60 frame

3Press the ] button to select the output timing.

4Press the l (or j) button, to set “FIELD” or “FRAME”.

FIELD . . . . . . . . . . 1 pulse is output after each set number of fields.

FRAME . . . . . . . . . 1 pulse is output after each set number of frames.

5Press the ] button.

°The “3H” setting starts flashing.

6Press the l (or j) button, to set the “3H”.

Y . . . . . . . . . . . . . . When recording in 3-hour mode, a pulse signal is output.

N . . . . . . . . . . . . . . When recording in 3-hour mode, a pulse signal is not output.

7Press the PAUSE/SCAN button, the normal screen is displayed.

REMOTE Jack

•You can use a VA-RMN01 Remote Control Unit (sold separately) to control remotely the VCR.

•Remote control of the VCR is possible by connecting a remote controller with a circuit such as indicated below, to the REMOTE jack.

NOTES:

•Use a 3.5 mm mini-jack type plug.

•The connection should be done using a shielded cable no more that 5 meters long.

Remote control circuit

GB

R1	1.5K	SW1: STOP
R2	0.43K	SW2: PAUSE/STILL
R3	0.51K	SW3: REW
R4	0.62K	SW4: FF
R5	0.75K	SW5: PLAY
R6	0.91K	SW6: REC
R7	1.1K	SW7: MENU
R8	1.3K	SW8: Do not use
R9	2.0K	SW9: TIMER, j

R10 2.4K	SW10: REC/PLAY SPEED, l
R11 3.6K	SW11: TRACKING/V.STILL –, ]
R12 5.6K	SW12: TRACKING/V.STILL +, «

The resistance tolerance is 2% or less.

NOTES:

•The functions not available on the VCR will not operate.

•The REC/PLAY SPEED j button on the VA-RMN01 will function as the TIMER button on the VCR.

26 English