7.Set the 
switch on the back of the satellite receiver to CH4. The TV will lose the picture from the satellite receiver, but this is OK.
Note: If your satellite receiver does not have a 
switch, see your satellite receiver’s User’s Guide for how to set TV Set Out on the satellite receiver to channel 4.
8. Press and hold | until both SAT | T V lights turn |
on (it takes about five seconds). |
| |
9.Release 
. SAT light will flash. 10.Enter
11.Press MUTE while watching SAT light.
12. SAT light will flash three times.
If the light does not flash at all, repeat this procedure starting with step 8.
13.Press 
while watching your TV. If your TV tunes to Channel 4, go to step 14. If not, go to step 7.
14.Press the MENU button. If you see the satellite receiver Menu screen, check the box below and go to step 28.
4
15.Answer the questions in Table 1. The information you provide is what you will use to teach your remote control to change the channel on your TV correctly.
118866 | 9 |