Dish Network EZ Using When a VCR is Installed, To Pass Satellite Programming Through Your VCR to

Page 21

16.If the information in step 2 on page 15 is a “3,” write the numbers you circled in Table 2 into the blank in step 21.

17.If the information in step 2 on page 15 is a “4,” write the numbers you circled in Table 2 into the blank in step 21, except replace the “3” with a “4.”

18.Press and hold

until both SAT

T V lights turn

on (it takes about five seconds).

 

 

19.Release

. SAT

light will flash.

 

 

20.Press the RECALL button.

 

 

21.Press

 

 

 

 

 

.

22.Press the MUTE button while watching

SAT

light.

 

 

 

 

23.If the

 

SAT

light flashes three times, go to step 24.

If

 

SAT

 

light does not flash at all, go back to step 18.

 

 

 

 

 

 

 

 

 

24.Press . You should see both your TV and your VCR change to the channel you wrote in step 21 above so that you can watch satellite programming.

25.Press the MENU button. If you see the satellite receiver Menu screen, go to step 26. If not, go to step 15 on page 18.

26.You are finished programming the remote control.

USING WHEN A VCR IS INSTALLED

If you installed a VCR using the instructions in Setting Up

to Pass Satellite Programming Through Your VCR to

Your TV on page 14, but you would like to use to switch your TV to the preferred off-air channel, make sure

your VCR is turned off before pressing .

20

118866

Image 21
Contents EZDISHCANCELtwrkE Contents of this Guide EZ Remote Buttons and Features Overview About the Dish Network EZ Remote ControlInstalling Batteries Setting UP to Switch the TV to Watch Satellite Programming Receiver UpgradeConnect a coaxial cable between the TV Set Out on None work, go to How to Scan for TV and VCR Press and to change channels on your TV 118866 How I Change My TV Channels Light will flash Press Off-Air Antenna Connections 118866 Setting UP to Switch the TV to a Preferred OFF-AIR ChannelSetting UP on the Remote Control Your TV Connecting Your Satellite RECEIVER, VCR, and TV Connecting a Satellite Receiver, VCR Setting UP on Your Remote Control Write the number in from page 15 into the blank in below How I Change My VCR Channels To Pass Satellite Programming Through Your VCR to Using When a VCR is InstalledOther Remote Control Instructions Lights turn on it takes HOW to Check the TV Codes HOW to Remove TV Codes HOW to USE the Remote Control Press the Menu button to open the Main Menu UP/DOWN/LEFT/RIGHT Buttons Cancel Cancel Button Dish Button Press the Power button to turn the TV on or off Use the Channel UP/DOWN buttons to change channels on the TV AOC TV and VCR CodesCXC JVC JBLLXI KTVMGA MTCRCA SSS SBRTMK ASA VCR CodesDBX CCEITT KLHMEI 544 STS Technics 553 Teknika 554, 588 Limited Warranty Advance Exchange Program Post Receipt Exchange Program 118866 Regulatory Factors