Dish Network EZ manual HOW to Remove TV Codes

Page 25

HOW TO REMOVE TV CODES

If you decide to change the TV you are using with the remote control, it is a good idea to remove the TV code from the remote.

1.

Press and hold

until SAT

T V lights turn on (it

 

takes about five seconds).

 

2.

Release

.

T V light flashes.

 

3.Press T V . T V stays on.

4.Enter 9-9-9-9with the keypad.

5.Press the MUTE button.

6.The T V light will flash three times.

The TV code is now cleared from the remote control’s memory. The TV channel also is reset back to “ 0-3 for the next time you set up a new TV code in your remote control.

HOW TO REMOVE VCR CODES

If you decide to change the VCR you are using with the remote control, it is a good idea to remove the VCR code from the remote.

1.

Press and hold

until

SAT

T V lights turn on (it

 

takes about five seconds).

 

 

2.

Release

.

T V light flashes.

3.

Press the RECALL button.

T V

stays on.

4.Enter 9-9-9-9with the keypad.

5.Press the MUTE button.

6.The T V light will flash three times.

The VCR code is now cleared from the remote control’s memory. The VCR channel also is reset back to “ 0-3 for the next time you set up a new VCR code in your remote control.

24

118866

Image 25
Contents EZDISHCANCELtwrkE Contents of this Guide EZ Remote Buttons and Features Overview About the Dish Network EZ Remote ControlInstalling Batteries Setting UP to Switch the TV to Watch Satellite Programming Receiver UpgradeConnect a coaxial cable between the TV Set Out on None work, go to How to Scan for TV and VCR Press and to change channels on your TV 118866 How I Change My TV Channels Light will flash Press Off-Air Antenna Connections 118866 Setting UP to Switch the TV to a Preferred OFF-AIR ChannelSetting UP on the Remote Control Your TV Connecting Your Satellite RECEIVER, VCR, and TV Connecting a Satellite Receiver, VCR Setting UP on Your Remote Control Write the number in from page 15 into the blank in below How I Change My VCR Channels To Pass Satellite Programming Through Your VCR to Using When a VCR is InstalledOther Remote Control Instructions Lights turn on it takes HOW to Check the TV Codes HOW to Remove TV Codes HOW to USE the Remote Control Press the Menu button to open the Main Menu UP/DOWN/LEFT/RIGHT Buttons Cancel Cancel Button Dish Button Press the Power button to turn the TV on or off Use the Channel UP/DOWN buttons to change channels on the TV AOC TV and VCR CodesCXC JVC JBLLXI KTVMGA MTCRCA SSS SBRTMK ASA VCR CodesDBX CCEKLH ITTMEI 544 STS Technics 553 Teknika 554, 588 Limited Warranty Advance Exchange Program Post Receipt Exchange Program 118866 Regulatory Factors