Dish Network EZ manual Light will flash Press

Page 12

16.Write the number(s) you circled into the blank in step 19.

17.Press and hold

until both SAT

T V lights turn

on (it takes about five seconds).

 

18.Release

. SAT

light will flash.

 

19.Press

 

 

 

(Fill in this blank with the exact sequence you circled in Table 1)

20.Press the MUTE button while watching SAT light.

21.If the

SAT light flashes three times, go to step 22.

If

SAT

light does not flash at all, go back to step

 

 

 

17.

 

22.Press. If your TV tunes to Channel 3, go to step 23. If not, go back to step 15.

23.If you want to keep your satellite programming on TV Channel 3, check the box below and go to step 28.

3

24.If you prefer to have your satellite programming on TV Channel 4, check the box below and go to step 25.

4

25.In the blank below, write down the numbers you circled in Table 1, except replace “ 3” with “ 4.

26.Cross out “0-4” on step 10 (page 9) and in the blank next to the crossed-out text write what you wrote in step 25.

27.Repeat steps 7 through 14 on page 9, including the changes you made to step 10.

28.You have completed setting up the button and TV control features of the remote control.

118866

11

Image 12
Contents EZDISHCANCELtwrkE Contents of this Guide EZ Remote About the Dish Network EZ Remote Control Buttons and Features OverviewInstalling Batteries Receiver Upgrade Setting UP to Switch the TV to Watch Satellite ProgrammingConnect a coaxial cable between the TV Set Out on None work, go to How to Scan for TV and VCR Press and to change channels on your TV 118866 How I Change My TV Channels Light will flash Press Setting UP to Switch the TV to a Preferred OFF-AIR Channel Off-Air Antenna Connections 118866Setting UP on the Remote Control Your TV Connecting Your Satellite RECEIVER, VCR, and TV Connecting a Satellite Receiver, VCR Setting UP on Your Remote Control Write the number in from page 15 into the blank in below How I Change My VCR Channels Using When a VCR is Installed To Pass Satellite Programming Through Your VCR toOther Remote Control Instructions Lights turn on it takes HOW to Check the TV Codes HOW to Remove TV Codes HOW to USE the Remote Control Press the Menu button to open the Main Menu UP/DOWN/LEFT/RIGHT Buttons Cancel Cancel Button Dish Button Press the Power button to turn the TV on or off Use the Channel UP/DOWN buttons to change channels on the TV TV and VCR Codes AOCCXC JBL JVCKTV LXIMGA MTCRCA SBR SSSTMK VCR Codes ASACCE DBXITT KLHMEI 544 STS Technics 553 Teknika 554, 588 Limited Warranty Advance Exchange Program Post Receipt Exchange Program 118866 Regulatory Factors