Dish Network EZ manual Lights turn on it takes

Page 23

HOW TO SCAN FOR VCR CODES

If the code for your VCR is not in the VCR Codes tables starting on page 39, complete the following instructions to scan for your VCR’s code.

1.

Make sure your VCR is on.

2.

Hold

until

SATT V

lights turn on (it takes

 

about five seconds).

 

3.

Release

. T V

light flashes.

4.

Press the RECALL button.

T V light stays on.

5.Pressor until the VCR turns OFF. You will have to do this repeatedly to scan through all codes.

Note: If T V flashes eight times, you have tried every code in the remote control.

6. Press the MUTE to finish programming the remote control. The T V light will flash three times.

7.Press while looking at the channel number display on your VCR. If the VCR is trying to change channels to Channel 3 (or 4), you have found the correct code for your VCR and you may

want to go back to page 17 to set up . If the VCR is not trying to change channels, go back to step 2 to find another code.

Note: The way your VCR displays channel numbers may differ from the description above. See the User’s Guide that came with your VCR for more information.

22

118866

Image 23
Contents EZDISHCANCELtwrkE Contents of this Guide EZ Remote Buttons and Features Overview About the Dish Network EZ Remote ControlInstalling Batteries Setting UP to Switch the TV to Watch Satellite Programming Receiver UpgradeConnect a coaxial cable between the TV Set Out on None work, go to How to Scan for TV and VCR Press and to change channels on your TV 118866 How I Change My TV Channels Light will flash Press Off-Air Antenna Connections 118866 Setting UP to Switch the TV to a Preferred OFF-AIR ChannelSetting UP on the Remote Control Your TV Connecting Your Satellite RECEIVER, VCR, and TV Connecting a Satellite Receiver, VCR Setting UP on Your Remote Control Write the number in from page 15 into the blank in below How I Change My VCR Channels To Pass Satellite Programming Through Your VCR to Using When a VCR is InstalledOther Remote Control Instructions Lights turn on it takes HOW to Check the TV Codes HOW to Remove TV Codes HOW to USE the Remote Control Press the Menu button to open the Main Menu UP/DOWN/LEFT/RIGHT Buttons Cancel Cancel Button Dish Button Press the Power button to turn the TV on or off Use the Channel UP/DOWN buttons to change channels on the TV AOC TV and VCR CodesCXC JVC JBLMTC KTVLXI MGARCA SSS SBRTMK ASA VCR CodesDBX CCEMEI ITTKLH 544 STS Technics 553 Teknika 554, 588 Limited Warranty Advance Exchange Program Post Receipt Exchange Program 118866 Regulatory Factors