Dish Network 3.1, 3.0, 3.2 warranty Using the Recover Button

Page 19

USING THE RECOVER BUTTON

Use this procedure works only if you have accidentally changed the TV channel or video input. It does not recover lost satellite signal.

Note: RECOVER will first try to tune your TV to channel 3, then channel 4, and then other video inputs with each press of the RECOVER button. You may need to press the RECOVER button up to 30 times to recover your satellite TV video.

1.Press and hold the RECOVER button until all four mode buttons light, and then let go of the button. The SAT mode button flashes twice and then all four mode buttons flash three times.

2.Press the RECOVER button. Wait for the TV mode button to flash once and then all four mode buttons to flash once.

3.If you see the System Info screen, press the SELECT button to close the screen. You have recovered your satellite video.

4.If you do not see the System Info screen, repeat steps 2 and 3 until you have recovered your satellite video.

Note: Press any remote control button other than the RECOVER button to end this procedure.

PROGRAMMING THE RECOVER BUTTON TO TUNE THE TV TO A SPECIFIC CHANNEL

The RECOVER button can be programmed to tune your TV back to the TV channel you use to watch satellite programming.

1.Program your remote to control your TV using the instructions in Setting Up to Control Other Devices on page 8.

2.Press and hold the TV mode button until all the other mode buttons light up, and then let go of the button. The TV mode button flashes.

3.Press the STAR (*) button.

4.Enter the three digits of your channel number. For example, if your remote TV is set to channel 60, enter 0-6-0.

5.Press the POUND (#) button. The TV mode button flashes three times.

18

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Regulatory Factors Safety InstructionsWireless Remote Control InstallationTable of Contents Models Supported by this Guide Remote Control BasicsUHF and IR Signals Installing BatteriesConverting the 4.0 Remote Control Setting UP to Control the Satellite Receiver Select Enable from the TV1 UHF Pro Setup screen Checking the Remote Address Combination Devices Setting UP to Control Other DevicesLimited Mode Setting UP Using Device Code TablesOnly for limited mode, Press Setting UP Using Device Code ScanChecking the Device Codes To set the remote to control the device’s volume Switching Between TV and Device Volume ControlOperating Modes Remote Control OperationTV/VIDEO Button Controlling the Satellite Receiver SAT Mode ButtonPower Buttons Volume ButtonGuide Button Mute ButtonMenu Button UP and page Down ButtonsInfo Button Arrow ButtonsSelect Button Recall ButtonNumber Buttons Cancel ButtonView TV Button Dish ButtonStar * Button Recover ButtonPound # Button Using the Recover Button Controlling a TV or a Second TV TV Mode ButtonUP/DOWN Arrow Buttons Power Button VCR Mode ButtonControlling a VCR or a Second VCR or a DVD Player VCR Buttons Controlling a Tuner or Amplifier AUX Mode ButtonSelect Button Device Codes TV CodesJBL MTC SBR VCR Codes STS DVD Player Codes TV/VCR Combo CodesTuner Codes Amplifier TUNER/AMPLIFIER CodesCodes DVD/VCR ComboWhat’s What’s Wrong What You Can Do Happening TroubleshootingTo use. See Remote Control Setup Limited Warranty Advance Exchange Program Post Receipt Exchange Program Accessory WarrantySee Troubleshoot the Remote on If YOU Need HelpPage Page Page Page
Top Page Image Contents