Dish Network 3.2, 3.0, 3.1 Controlling the Satellite Receiver SAT Mode Button, TV/VIDEO Button

CONTROLLING THE SATELLITE RECEIVER

SAT MODE BUTTON

Press this button to set the remote to SAT (“satellite”) mode to control the receiver. The SAT mode button’s back light stays lit for about two seconds to show you’ve set the remote to SAT mode. Make sure you keep the remote in SAT mode to use the buttons following buttons.

Note: Your satellite receiver may not provide all of the functions described below. Consult your receiver’s user guide for the features your receiver provides.

TV/VIDEO BUTTON

If you connect the receiver with its back panel TV ANTENNA/CABLE IN and TV SET OUT ports, use this button to switch the receiver between the satellite signal (connect it to the SATELLITE IN port) and another video signal like a cable or broadcast TV antenna input (connect it to the receiver’s TV ANTENNA/CABLE IN input).

POWER BUTTONS

Press the blank POWER button to turn the receiver on or off. Press the TV POWER button to turn your TV off and on.

Note: You must set up the remote to control the TV for the TV POWER button to work. See Setting Up to Control Other Devices on page 8.

VOLUME BUTTON

Press this button to raise (+) or lower (-) the TV sound volume.

Note: You must set up the remote to control the TV for the VOLUME button to work. See Setting Up to Control Other Devices on page 8.

13