5.If you are converting the remote to operate like a second UHF
Pro remote to control the 
side of the DISH 322 receiver, then get the green 1 UHF Pro key provided separately. Install this key in the remote with the UHF Pro marking showing.
Note: Key has the
UHF Pro marking.
If you set up your DISH 322 to operate the 
side using UHF Pro, the two UHF Pro remotes for this receiver will interfere with each other when operated at the same time. This may prevent the remotes from operating the receiver momentarily.
6.If you have not already installed batteries, install them now. See Installing Batteries for further details.
7.Slide the battery cover back into place.
SETTING UP TO CONTROL THE SATELLITE RECEIVER
The remote and the receiver must be set up on the same address
so that the remote can control the receiver. When you get the remote, it's already set up to control the receiver on address 1. However, your receiver may be set to a different address or, in the case of the DISH 322, may need some additional setup. To set up the remote and receiver to work together on the same address, use the following instructions.
5