Dish Network 3.1, 3.0 warranty Regulatory Factors, Safety Instructions, Wireless Remote Control

Page 1

REGULATORY FACTORS

WIRELESS REMOTE CONTROL

This device complies with Part 15 of FCC Rules. Operation is subject to the following two conditions:

(1)this device may not cause harmful interference, and

(2)this device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications to this device may void your authority to operate this equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the use is encouraged to try to correct the interference by one or more of the following measures:

Re-orient or relocate the receiving antenna.

Increase the separation between the equipment and receiver.

Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

SAFETY INSTRUCTIONS

You must keep safety in mind while using this device. Keep these and any other instructions for future reference.

INSTALLATION

Observe Warnings: Carefully follow all warnings on the device and in the operating instructions.

Heat: DO NOT place the device near heat sources such as radiators, stoves, heat registers, or other appliances that produce heat.

CARE AND USE

Cleaning: DO NOT use liquid, abrasive, solvent, or aerosol cleaners. Use a damp cloth for cleaning.

When Not in Use: Remove the batteries if this device is to be left unattended or unused for a long period of time.

Refer servicing to qualified personnel when a solid object or liquid has fallen onto or into the device.

DO NOT attempt to service this device. Refer all servicing to qualified personnel. Opening covers other than the battery cover will void the warranty.

Image 1
Contents Wireless Remote Control Safety InstructionsInstallation Regulatory FactorsTable of Contents Models Supported by this Guide Remote Control BasicsUHF and IR Signals Installing BatteriesConverting the 4.0 Remote Control Setting UP to Control the Satellite Receiver Select Enable from the TV1 UHF Pro Setup screen Checking the Remote Address Limited Mode Setting UP to Control Other DevicesSetting UP Using Device Code Tables Combination DevicesOnly for limited mode, Press Setting UP Using Device Code ScanChecking the Device Codes To set the remote to control the device’s volume Switching Between TV and Device Volume ControlOperating Modes Remote Control OperationPower Buttons Controlling the Satellite Receiver SAT Mode ButtonVolume Button TV/VIDEO ButtonMenu Button Mute ButtonUP and page Down Buttons Guide ButtonSelect Button Arrow ButtonsRecall Button Info ButtonView TV Button Cancel ButtonDish Button Number ButtonsStar * Button Recover ButtonPound # Button Using the Recover Button Controlling a TV or a Second TV TV Mode ButtonUP/DOWN Arrow Buttons Power Button VCR Mode ButtonControlling a VCR or a Second VCR or a DVD Player VCR Buttons Controlling a Tuner or Amplifier AUX Mode ButtonSelect Button Device Codes TV CodesJBL MTC SBR VCR Codes STS DVD Player Codes TV/VCR Combo CodesTuner Codes Amplifier TUNER/AMPLIFIER CodesCodes DVD/VCR ComboWhat’s What’s Wrong What You Can Do Happening TroubleshootingTo use. See Remote Control Setup Limited Warranty Advance Exchange Program Post Receipt Exchange Program Accessory WarrantySee Troubleshoot the Remote on If YOU Need HelpPage Page Page Page