Radio Shack 7-in-1 Remote Control with Lighted Keypad manual

15-1924.fm Page 10 Monday, July 19, 1999 12:50 PM

5.Point the 7-in-1 Remote Control at your device and press POWER (All Lts On) (or CHANNEL + (On) for some cable boxes). Your device should turn off (or on, if it was off).

If the remote does not operate your device, try the other codes listed in “Manufacturers’ Codes” on Page 23 for your brand of TV, VCR, cable converter, or other device.

6.Repeat Steps 2–5 for additional devices.

Using Two or More Similar Devices

If you have two or more similar devices (two VCRs for example) and you have already pro- grammed the 7-in-1 to control one of the devices using that device key, you can program the AUX1 and AUX2 device keys or an unused device key to control the additional device.

Follow these steps to program AUX1 or AUX2.

1.Repeat Step 1 and 2 under “Setting Up Your 7-in-1” on Page 9.

2.Press AUX1 or AUX2.

3.If you are replacing a CD’s remote control, skip to Step 4. Otherwise, press the device key for the type of remote you are replacing (VCR, CBL, TV, CD, Plug ’n Power, or SAT.

Note: If you do not press a device key within about 15 seconds, the red light flashes for about 3 seconds then turns off. Start again from Step 1.

4.Repeat Steps 4–6 under “Setting Up Your 7- in-1” on Page 9.

To program an unused device key to control an additional device, choose an unused device key that controls a similar type of device (see “Device Types” on Page 8), then program it using the steps in “Setting Up Your 7-in-1” on Page 9.

Need help? Call 1-800-989-4706