Radio Shack 7-in-1 Remote Control with Lighted Keypad owner manual Clearing All Commands

15-1924.fm Page 19 Monday, July 19, 1999 12:50 PM

from a VCR’s original remote control, press PLAY on the 7-in-1.

If the key you want to program is already used for another command, press SHIFT before pressing the key. For example, to store the command SHIFT-PLAY, press SHIFT then PLAY on the 7-in-1.

7.On the original remote control, hold down the key that you want your 7-in-1 to learn until the red light on the 7-in-1 blinks once.

Note: If the command was not programmed properly, the red light blinks for about 3 sec- onds then turns off. If this happens, repeat Steps 4–7.

8.Repeat Steps 1–7 to store more commands.

9.When you finish, press ENT on the 7-in-1 to save all stored commands.

Note: If you do not press a key within 15 seconds, the red light blinks for about 3 seconds then turns off. Begin again from Step 1.

Clearing All Commands

1.Hold down SET UP on the 7-in-1 until the red

light above turns on.

2.Press the device key on the 7-in-1 for which you want to clear all commands. The red light blinks once.

3.Press LEARN on the 7-in-1 twice. The red light flashes for a few seconds.

4.Press SET UP on the 7-in-1. After a few sec- onds, the red light flashes then turns off.

Need help? Call 1-800-989-4706

19