Radio Shack 7-in-1 Remote Control with Lighted Keypad specs

15-1924.fm Page 13 Monday, July 19, 1999 12:50 PM

Entering a Plug ’n Power House Code

Your IR Command Console or Plug ’n Power Wireless Remote Control System uses a master code called a house code (see your IR Command Console’s or Plug ‘n Power Wireless Remote Control System’s Owner’s Manual for more infor- mation).

1.Press Plug ’n Power on the 7-in-1 Remote Control.

2.Hold down SET UP on the 7-in-1 until the red

light above turns on.

3.Use the 7-in-1’s number keys to enter the numbers equivalent to the house code’s let- ters (1 for A, 2 for B, 3 for C, and so on).

For example, if the house code is C, press 3.

4.Press ENT on the 7-in-1.

When the red light turns off, the 7-in-1 has accepted the code.

Note: If the code you entered is invalid, the red light flashes for about 3 seconds then turns off. Start again from Step 1.

Controlling Lights and Appliances Using an IR Command Console

Follow these steps to control Plug ’n Power mod- ules with your 7-in-1 using an IR command con- sole.

1.Position the IR command console within the 7-in-1’s line of sight.

2.Plug the IR command console’s power cord into any standard AC outlet.

3.Set the house code dial on top of the IR com- mand console to the same letter as your Plug ’n Power modules.

4.Set the selector switch on the IR command console for the group of modules you want to control (1–4 or 5–8).

Need help? Call 1-800-989-4706