Radio Shack 7-in-1 Remote Control with Lighted Keypad Setting UP Your 7-IN-1, SET UP TV 1- 8

15-1924.fm Page 9 Monday, July 19, 1999 12:50 PM

SETTING UP YOUR 7-IN-1

1.Refer to “Manufacturers’ Codes” on Page 23 and write down the codes for your original remote controls.

Notes:

•Some manufacturers have several possi- ble codes listed. Try each until you find the right one. See “If You Have Problems” on Page 20 if you cannot find the correct code.

•If you want to set up your 7-in-1 to control a combination TV/VCR (such as Cat. No. 16-421 or 16-422), you must program the TV code for the TV functions and the VCR code for the VCR functions.

2.Hold down SET UP until the red light above

turns on.

Note: To exit the set up routine at any time, press SET UP again. The red light flashes several times.

3.Press the device key for the type of remote you are replacing (TV, VCR, CBL, CD, Plug ’n Power, or SAT).

Note: If you do not press a device key within about 15 seconds, the red light flashes for about 3 seconds then turns off. Start again from Step 2.

4.Enter the 3-digit code.

For example, to replace a TV’s remote con- trol (manufacturer’s code 185), press:

SET UP – TV – 1– 8 – 5

When the red light turns off, the 7-in-1 has accepted the code.

Note: If the code you entered is invalid, the red light flashes for about 3 seconds then turns off.

Need help? Call 1-800-989-4706

9