Radio Shack 7-in-1 Remote Control with Lighted Keypad owner manual Determining the 3-Digit Code

15-1924.fm Page 21 Monday, July 19, 1999 12:50 PM

•Because the 7-in-1’s library has so many codes, this procedure can take several minutes.

•If your device turns off during the search, but does not operate after you lock in the code, begin the search again, pausing longer between key presses.

If necessary, repeat these steps for each device.

Determining the 3-Digit Code

After you set up your 7-in-1 Remote Control using manual code search, you can find which 3-digit code the 7-in-1 Remote Control is set to by follow- ing these steps.

1.Hold down SET UP until the red light above

turns on.

2.Press the device key you want to get the manufacturer’s code from. The red light blinks once then stays on.

3.Press SET UP. The red light blinks once then stays on.

4.Press 0 – 1 – 2 – 3 – 4 – 5 – 6 – 7 – 8 – 9, wait- ing a few seconds after you press each num- ber before you press the next one.

If the red light blinks after you press a num- ber, that number is the first number of your 3- digit manufacturer’s code.

5.Repeat Step 4 twice to find the second and third numbers of your 3-digit manufacturer’s code. After the red light blinks for the third digit in the code, it turns off.

Need help? Call 1-800-989-4706

21